AND INTEGRO ARE TRADEMARKS OF GLASDON GROUP AND ITS SUBSIDIARIES IN
THE U.K. AND OTHER COUNTRIES.
Replacement components are available direct from GLASDON.
GLASDON cannot be held responsible for claims arising from incorrect installation, unauthorised modifications or misuse of
the product.
Issue 1
May 2012
C000/00423
© Copyright 2012
Glasdon U.K. Ltd reserves the right to alter specifications without prior notice.
Glasdon U.K. Limited
Preston New Road
BLACKPOOL
Lancashire FY4 4UL
Tel: 01253 600410
Fax: 01253 792558
E-mail: [email protected]
Web: www.glasdon.com
P. 4
WALL MOUNTING
Fig. M
Fig. N
Kit
Contents:
ITEM 1
M8 x 100mm Bolt
x 4
ITEM 2
Steel Sleeve
x 4
ITEM 3
M8 x 20mm Washer x 4
Tools Required:
M6 x 120mm Masonry Drill Bit
Hand Drill
12mm Torque wrench
1.
Drill through the 4 points in circular
recesses in the back internal wall of
the bin as shown in Fig. L.
2.
Hold the bin against the wall at the
desired height and mark the 4 off
hole positions.
3.
Drill the 4 marked holes with the
M6 Drill Bit (Fig. M).
4.
Remove any dust or debris from the
4 holes.
5.
Insert bolts (Item 1), sleeves (ITEM
2) and washers (Item 3) through the
bin and into the wall (Fig. N). Apply
pressure and screw into the wall with
a 12mm wrench. Tighten to 25Nm.
NOTE: Suitable for use in concrete, brick,
block and stone walls. Any other walls
should be individually assessed and the
appropriate fixings utilised with 20mm
diameter washers.
Fig. L
