4
10. Inspect the cabinet from the sides to ensure both the top and
bottom wall-mounting brackets are fully engaged in their
respective slots as shown.
Install Cabinet to Standard Wall
IMPORTANT:
■
Remove the GearWall™ mounting bracket(s) before installing
the wall cabinet on your standard wall.
■
Use the round holes in the rear cabinet wall to mount the wall
cabinet to your garage wall studs.
1. Locate the wood studs in your garage wall and mark the
holes.
2. Using 2 or more people, align 4 corresponding holes in the
cabinet with the marks on the wall.
3. While 2 or more people hold the cabinet in place on the wall,
attach the wall cabinet to the garage wall using the
¹⁄₄
in. flat
washers and lag screws.
4. Using a
⁷⁄₁₆
in. wrench, fully tighten the bolts.
Shelf Adjustment
24 in. (60.96 cm) Cabinet
The 24 in. (60.96 cm) cabinet has 1 fixed shelf. No adjustment is
required.
30 in. (76 cm) Cabinet
To Remove the Shelves
1. Remove the shelf clips from their shipping position on the
sides of the cabinet. Discard the clips.
2. Lift up on the underside of the shelf until the shelf edges are
free of the cabinet tabs.
3. Tilt the shelf up to reposition it within the cabinet or to remove
it from the cabinet.
To Replace the Shelves
NOTE: Plan your shelf heights and install shelves starting from
the bottom. The shelves are supported by the metal tabs on the
back and side walls of the cabinet.
1. Determine the placement of the shelves.
2. Tilt the shelf so that one end is higher than the other as
shown.
3. Insert the shelf into the cabinet so that the higher end and the
rear edge are directly above the desired metal tabs and push
down to snap shelf edges in place behind the rear and side
tabs.
NOTE: As the lower shelf edge slides upward it will press in the
tab, allowing it to pass.
4. Raise the lower end so it is directly above the desired tab and
push down to snap shelf edge in place behind the side tab.
5. Make sure the shelf edges are in place behind all the tabs and
the shelf is firmly supported.
6. Repeat this process for the other shelf.
Door Adjustment
The cabinets are designed with adjustable door(s).
1. Using a Phillips screwdriver, loosen all screws attaching the
hinge to the cabinet.
2. Adjust door to the desired height.
3. Tighten the screws.
Door Reversal
(24 in. [60.96 cm] wall cabinets only)
1. Using a Phillips screwdriver, remove all the screws securing
the cabinet door hinge to the cabinet. Set the cabinet door
aside.
2. Remove the nut securing the cabinet door latch to the wall
cabinet. Reattach the cabinet door latch to the hole on the
opposite side of the wall cabinet.
3. Using the screws removed in Step 1, reattach the cabinet
door hinge to the opposite side of the cabinet.
1. Push down
2. Lift up
1
2
