4
24" (60.96 cm) Cabinet
2.
Attach bracket
3.
Install cabinet
A. Bracket rim
A. Bracket rim
C. Mounting bracket fully engaged
B. Slot
With the rims of a mounting bracket pointing down, align the
holes in the bracket with the pair of holes in the back panel.
Working from the back, insert a 1/4"- 20 x 1/2"carriage bolt (F1)
through the bracket and back panel as shown. Working from the
cabinet interior, fasten each bolt with a washer (F2) and
a hex nut (F3). Completely tighten the nuts.
IMPORTANT:
If installing cabinet on GearTrack
®
channel, a
second channel should be installed 18" (45.72 cm) below the
bottom of the supporting channel so the cabinet will hang level.
Close the cabinet door. Determine cabinet mounting location on
a GearWall
®
panel or GearTrack
®
channels. Using two or more
people, engage the mounting bracket into the wall slots by lifting
up, pushing toward the wall and lowering the bracket rims into
the slots as shown. Make sure the mounting bracket is fully
engaged in the slots as shown. If you want to reverse the door,
see “Reverse Door.” Permanently affix the magnetic latch to the
cabinet by removing the paper backing from the adhesive and
firmly pressing it to the cabinet.
A
B
C
A
30" (76 cm) Cabinet
2.
Attach bracket
3.
Install cabinet
A. Bracket rim
C. Mounting bracket fully engaged
B. Slot
With the rims of a mounting bracket pointing down, align the
holes in the bracket with the pair of holes in the back panel.
Working from the back, insert a carriage bolt (F1) through the
bracket and back panel. Working from the cabinet interior, fasten
each bolt with a washer (F2) and a hex nut (F3). Completely
tighten the nuts. With the rims of the mounting bracket pointing
down, align the holes in the bracket with the pair of slots in the
back panel. Working from the back, insert a carriage bolt (F1)
through the lower bracket and back panel. Working from the
cabinet interior, fasten each bolt with a washer (F2) and
a hex nut (F3). Only hand tighten the nuts. The lower bracket will
need to be adjusted to mount the cabinet on the wall.
IMPORTANT:
Completely tighten the hex nuts (F3) on the lower
bracket after mounting the cabinet on the wall.
Close the cabinet doors. Determine cabinet mounting location
on GearWall
®
panel or GearTrack
®
channels. Using two or more
people, engage the top mounting bracket into the wall slots by
lifting up, pushing toward the wall and lowering the bracket rims
into the slots as shown. Make sure the top mounting bracket
is fully engaged in the slots as shown. Open the cabinet doors.
From the cabinet interior, lift up on the two lower bolts to adjust
the lower mounting bracket so that it aligns with the slots on
the GearWall
®
panel or GearTrack
®
channels. Push the cabinet
toward the GearWall
®
panel or GearTrack
®
channels and lower the
lower bracket rims into the slots. Make sure the bottom mounting
bracket is fully engaged in the slots. Using a 1/2" wrench, tighten
the two nuts on the bottom wall mounting bracket.
B
C
A
F1
F2
F3
F1
F2
F3
F1
F2
F3
F1
F2
F3
F1
F2 F3
F2
F3
25-Feb-2021 08:06:20 EST | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
