6
1.
Bumper Assembly
3.
Use, Remove and Replace
the Drawers
2.
LED Light Assembly
F4.
6 mm washer
F5.
M6 Hex-head
bolt
F5
F4
A
Using 6 mm Hex-head bolts (F5) (8) and 6 mm washers (F4) (8),
fasten a bumper to each corner of the cabinet. Completely tighten
all the fasteners.
NOTE:
To keep from stripping the bolts, do not overtighten.
NOTE:
The key locks the lid and all of the drawers. Use the
drawer liners to avoid scratching or damaging the drawers.
REMOVING THE DRAWER
Unload the contents from the drawer. Slide out the drawer as far
as it will go. Press the lever down on the right-hand track and lift
the lever up on the left track to release the drawer. Pull the drawer
out the rest of the way.
REPLACING THE DRAWER
Align the drawer guides with the receiving glides. Hold the
receiving glides firmly and insert the drawer guide.
NOTE:
It is normal for the drawer to close tightly the first time
after it has been removed.
Push the drawer in completely.
The included LED light is used to illuminate the upper chest tray
area. The LED light is magnetic and may be positioned anywhere
on the inside flat surface of the lid. The LED light is powered by
the USB port on the powerstrip. Route the included USB cable
as shown. The wire should be positioned behind the center lid
support. Use the two self-adhesive cable clips to hold the USB
cable in position as shown. After assembly, make sure the lid
closes and the USB cable stays within the tray area and does not
contact the hinge, lid opening, or any moving parts.
F4
LED light
Cable clip
Cable clip
USB cable
F5
A. Lever
FINAL ASSEMBLY
Using two or more people, lift the cabinet up and onto the casters.
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
10-Apr-2020 12:07:31 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
