4
ASSEMBLY INSTRUCTIONS
Tools and Parts
F1
F2
F3c
F5
5/16" Hex-
head bolt (24)
Flange nut (8)
Phillips-head
screw (4)
Small flange
nut (4)
Gather the required tools before starting installation.
Tools Needed:
■
1/2" Wrench
■
Phillips screwdriver
■
3/8" Wrench
■
Level
Tool Supplied:
■
Hex key
Part Supplied:
■
Key
Cabinet Use Requirements
■
Intended for use in a garage.
■
Maximum weight limit is 45 lbs (20 kg) for the shelf.
■
Maximum weight limit is 30 lbs (13 kg) for the drawer.
■
Maximum weight limit is 300 lbs (136 kg) for the cabinet.
Unpack the Cabinet
1.
Remove and verify the contents. Contents include a hex key, a
key, and the parts and fasteners shown in “Parts.”
2.
Dispose of/recycle all packaging materials.
Assemble Cabinet
IMPORTANT:
Two people may be required to complete the
assembly. As you assemble the cabinet, make sure the edges
with the holes are facing up. If you are assembling the cabinet on
the floor, fasten the eight front corner bolts, two at each corner,
after you stand the cabinet upright.
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
1.
Cabinet Assembly
Place side panel (P1) on a flat, firm surface so that the edge with
the holes is facing down as shown. Insert the cabinet top (P2)
between the edges of side panel (P1).
NOTE:
Make sure the edges with the holes are facing down.
Align the holes and attach the top (P2) to side panel (P1) using
six hex-head bolts (F1) and two 5/16" flange nuts (F2) as shown.
Do not tighten completely. Position side panel (P3) so that the
top (P2) is between the edges of side panel (P3). Align the holes
and attach the top (P2) to the side (P3) using six hex-head bolts
(F1) and two 5/16" flange nuts (F2) as shown. Do not tighten
completely. Insert cabinet bottom (P4) between the edges of side
panels (P1 and P3).
NOTE:
Align the holes and attach the bottom (P4) to the side
panels (P1 and P3) using six hex-head bolts (F1) and two
5/16" flange nuts (F2) for each side as shown. Do not tighten
completely.
P2
P1
P3
P3
P2
P4
