Gladiator GABC05FDKG, Use & Care Manual

Page: 6 / 40

6
Open the door to a 90° angle and remove the two screws for the
bottom door hinge.
Remove the door by pulling it forward and away from the
Beverage Cooler.
NOTE: There are two hinges for reverse door installation, one
for a right-hand door swing and one for a left-hand door swing.
Install the top hinge designed for the desired door swing.
Remove the three screws from the top hinge, and then remove
the hinge. Using the three screws removed in the previous step,
attach the correct top hinge to the upper reverse corner on the
front of the Beverage Cooler.
Remove the three decorative screws from the upper corner of the
front of the Beverage Cooler. Insert the three decorative screws
into the three holes in the upper reverse corner of the front of the
Beverage Cooler.
1.
Remove the bottom hinge
A. Bottom hinge pin
B. Door stop
C. Bottom hinge
A
B
C
2.
Remove the top hinge
Remove the screws for the door stop; remove door stop. Attach
the door stop to the reverse side of the door.
Attach the bottom hinge to the reverse side of the door. Insert the
top corner of the door into the top hinge pin and reinstall the door
on the Beverage Cooler. Press the door and the bottom hinge pin
onto the bottom hinge. Check the alignment of the door and the
door seals. Tighten the hinge screws (as necessary).
3.
Remove the door stop
4.
Attach the bottom hinge
Reverse Door Swing (Optional)