6
Installation (continued)
Installing the wax ring
Securing the toilet
Installing the tank
Installing the toilet
3
5
6
4
□
Turn the toilet bowl (B) upside down onto a towel or
cushioned surface. With the rounded (tapered) end of the
wax ring (CC) facing the toilet, place the wax ring (CC)
around the raised outlet ring of the bowl (B), and press
firmly enough so the wax ring (CC) adheres to the bowl
(B). If the supplied wax ring has a black plastic cone
extension, that should be facing away from the toilet.
□
From the backside of the toilet (B), place the plastic discs
(DD) over the floor bolts (AA), noting ‘THIS SIDE UP’ on the
top of the discs.
□
Tighten the floor bolt wing nuts (EE) onto the floor bolts
(AA) to secure the position of the plastic discs (DD).
□
Place the bolt cap covers (FF) over the floor bolts (AA) and
snap into place.
□
Attach the rubber sealing gasket (KK) to the center drain hole
under the tank (A).
□
Gently place the tank (A) on the toilet bowl (B) with bolts (II)
protruding out underneath.
□
Place an oval metal washer (LL) followed by a wing nut (MM)
onto each protruding bolt (II).
□
Tighten the wing nuts (MM) enough so that the tank (A) sits
level and secure on the toilet bowl (B). Make sure the tank (A)
is parallel to the wall and straight on the toilet bowl (B).
□
Place the toilet bowl (B) over the toilet flange (1) in
alignment with the floor bolts (AA) so they protrude
through the slots on the base of the toilet bowl (B). Press
down on the toilet bowl (B). Apply weight evenly. Do not
move after placement. Watertight seal may be broken.
NOTE:
Remember to remove temporary plug from
the floor flange prior to placing the bowl.
CAUTION:
Do not overtighten the nuts. May
cause severe damage.
CAUTION:
Do not overtighten the nuts. May
cause severe damage.
