5
HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
Installation (continued)
3
Installing the standpipe to
mixer
□
Thread the hot and cold supply onto the mixer
(K).
□
Install the standpipe (M) onto the mixer (K)
and tighten set screw (L) with the Hex wrench
(Hex: 2.0mm, F). Make sure that the screw
holes (1) are behind the standpipe (M).
4
Drilling the holes & Making the
waterline connections
□
Mark the locations for the screws with a pencil
(1). With an electric drill (2), drill three 1/4 in.
diameter holes for the screws in the floor.
Place the anchors (P) into the holes.
□
Connect the flexible supply lines (3) to the water
supplies (4).
NOTE:
Do not reverse the hot and cold supply.
6mm dia.
Floor
Floor
Cold inlet
supply line
Hot inlet
supply line
1
1
K
M
L
F
L
F
4
P
3
3
P
4
1
2
