7
Installation (continued)
Installing and adjusting the flush
button
Installing the seat with lid
7
8
□
Position the flush button mechanism (QQ) in tank lid so
the single drop button will align with blue button (half
flush) on top of the flush valve and double drop button
aligns with the grey button (full flush).
□
Secure the flush button mechanism (QQ) in the tank lid by
hand tightening the lock nut (1).
□
The rubber tip on the bottom of the push rods leading
from the flush buttons should be slightly backed off from
the top of the levers on the flush valve.
□
To increase the rod length, turn the rod locknut
counterclockwise to loosen, then rotate the push rod
counterclockwise to increase exposed length. When the
desired length is achieved, turn the rod locknut clockwise,
while holding the push rod, until it is tightened.
□
Connect the water supply line (not included) between the
tank (A) and shut-off valve.
□
Tighten the tank connection coupling nut ¼ turn beyond
hand tight.
□
Turn on the supply valve and allow the tank (A) to fill.
□
Check for leakage at all connections and tighten or correct
as needed.
NOTE:
Do not overtighten the tank connection.
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
