8
Installation (continued)
Troubleshooting
Your new toilet is made of stain-, acid- and abrasion-resistant vitreous china. Clean the outside surface with mild soap, warm water and
a soft cloth. On stubborn stains use a powdered detergent and damp sponge or nylon scouring pad. Never use abrasive scouring
powders, cleansers or pads because they will scratch, damage and dull the surface. The manufacturer shall not be responsible or liable
for any tank fitting damage caused by the use of cleaners containing chlorine (calcium hypochlorite). When cleaning your toilet seat,
wash it with mild soapy water. Rinse the seat thoroughly with clean water and dry with a soft cloth. Avoid detergents, disinfectants or
cleaning products in aerosol cans. NEVER use abrasive scouring powders on your seat. Some bathroom chemicals and cosmetics may
cause damage to the seat’s finish, so test your cleaning solution on an inconspicuous area before applying to the entire surface.
WARNING:
DO NOT USE IN-TANK CLEANERS. Products containing chlorine (calcium hypochlorite) can seriously damage
tank fittings potentially causing leaks, excessive water use and property damage.
Problem
Solution
If fill valve does not turn on,
will not turn off, or will not
refill the tank after the flush.
□
Remove top cap and check for debris. If you find debris or flow is week; Inspect lower section of fill
valve for partial blockage. Partial blockage may be at shut off valve or in water supply line.
(See “REMOVING THE VALVE CAP ASSEMBLY & FLUSHING OUT DEBRIS”)
□
If fill valve has been in use for some time and/or float cup does not drop when flushing tank, replace
seal with a genuine Fluidmaster 242 seal (See “IF REPLACING SEAL”)
The flush quality of the toilet
is poor.
□
Make sure the water level in the tank is up to the water line printed on the overflow tube of the flush
valve. To increase the water level, turn the adjustment screw on the fill valve clockwise to raise the
float cup.
□
Make sure the push rods are the correct length. The push rods should be set to a gap of
approximately 1/16 in. above the push buttons of the flush valve. To adjust, loosen the collar on the
push rod and turn the rod counterclockwise to extend the length. Tighten the collar to secure.
Water continues to run.
□
Check to make sure the rubber seal gasket on the flush valve is completely closed. Clear any debris
from the gasket surface and sealing area of the flush valve which may be obstructing full closure.
Care and Cleaning
Installing the seat with lid
9
□
Turn the toilet seat with lid (C) upside-down.
□
Insert the toilet seat hinge gasket (UU) onto the bottom of the hinge. Firmly
press the (4) raised bumpers into the associated openings of the hinge.
□
Insert the lock-bolt (NN) in the bolt trough (1), then adjust the lock-bolt (NN)
to make the hole distance match with the toilet.
□
Turn the toilet seat with lid (C) over so that the lock-bolts (NN)
protrude downward.
□
Insert the lock-bolts (NN) into the holes on the toilet (B) and adjust the toilet
seat and lid (C) to find the best assembly position.
□
Place the washer (OO) and the lock-nut (PP) onto the lock bolt (NN) from
underneath the toilet (B) and tighten the lock-nut (PP) firmly to secure the
seat and lid (C) in place on the toilet (B). Close the bolt trough covers and
snap into place.
II
GG
KK
HH
UU
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
PP
NN
RR
OO
