Sanitizing
Perform: Perform half Yearly, if required.
Time Required: 15 minutes.
Note: Do it prior to loading a fresh bottle.
1. To Clean the probe assembly unplug power cord from wall outlet.
2. Move combination unit away from wall and turn it 90 degrees in either
direction.
3. Turn power switches to OFF.
4. Remove water bottle and probe from water bottle.
5. Place a 2 gallons or larger bucket under the probe assembly.
6. Romove air filter and wash in soapy water.
7. Submerge probe in water and wash by hand if dirty. Rinse properly
by submerging in water.
8. Use a spray bottle to spray dispensing nozzles of water faucets with
a mild chlorine solution (1 teaspoon of unscented bleach in 12 oz of
water).
9. After 1 minute, rinse by spraying the nozzles with tap water.
10. Place probe into bottle filled with tap water. Install in cooler and
close door.
11. Dispense 1 Gallon of water from both faucets.
12. Remove bottle with tap water.
13. Install bottle with fresh water.
14. Dispense 1 gallon of water from both faucets.
15. If bleach smell still present repeat rinsing cycle.
16. Drain an water through drain plug at the back as deseribed .
17. Replace plug.
18. Place bottle with bottled water. Place probe into bottle.
19. Close the door and plug power cord into well outlet.
Air Filer
17
A
B
