18
HOW TO ADJUST WATER TEMPERATURE FOR HIGH ALTITUDE TO AVOID BOILING
HOW TO ADJUST WATER FILLING AMOUNT
In order to extract most of flavor from your Single Serve Cup your Brewer works at 201°F. It is
good for elevations under 2500 feet.
- Immediately after power cord is plugged into the electrical outlet, you will hear an audible signal.
- At the same time, touch buttons “PREHEAT” and “START” for 1 seconds, to enter into SET
mode. You will see all five (5) cup sizes' LED icons flashing.
- For altitude under 2800 Feet, you should touch button for “8 oz” for 1 second, until “8 oz” LED will
flash. Then touch START button to SET.
- For altitude under 5000 Feet, you should touch “10 oz” button for 1 second, until “10 oz” LED will
flash. Then touch START button to SET.
- For altitude under 7000 Feet elevation, you should touch “12 oz” button for 1 second, until “12 oz”
LED will flash, then touch START button to SET.
- Immediately after power cord is plugged into the electrical outlet, you will hear an audible signal.
- At the same time , touch together buttons for “10 oz” and “START” for 1 second, water will start
dispensing from the Brewer. When water reaches required level desired for middle cup setting
touch “START” button to stop dispensing. Setting for middle cup is completed. Output settings for
the other cups will be adjusted accordingly.
HOW TO CANCEL BLOW OFF TO DRY CUPS
(Suitable in case of open bottom cups or weakly glued lids. )
- Immediately after power cord is plugged into the electrical outlet, you will hear an audible signal.
- At the same time, touch together buttons for “PREHEAT” and “8 oz” for 1 second, to enter into
SET mode. My Cup light starts flashing.
- Touch “START” button to cancel Blow Off function. LED light for K-cup picture will turn OFF.
NOTE: This model has memory chip to retain your settings. To return to factory settings unplug
the power cord and plug back again after 3 seconds, Hold “PREHEAT” and “UNLOCK” at the
same time.
IMPORTANT NOTE:
Please touch "8 oz + 10 oz + 12 oz" simultaneously
If you want to set the addtional setting when unit is already plugged in.
