27
GKD Technik Ltd
M3000007
Rhino Horn/Jib Attachment
A Rhino Horn is a Jib Attachment that is mounted onto the machine at the Bucket Pin and is controlled by
the Bucket Linkage. It will have addi�onal Angle Sensors mounted to it to enable the 3RCI+ System to
monitor the angle of the Jib and ensure that the machine is prevented from exceeding any envelope
limits (Height, Slew or Virtual Wall) that have been set.
With the 3RCI+ System, Full Spaceguard is allowed even with the Rhino Horn/Jib attached.
Once the system is on the Operator screen, check
that the JIB li� point is automa�cally
selected. This will be shown here.
While the Rhino Horn/Jib is connected to the 3RCI+ System, the JIB Li�ing point will be the only li�ing
point available and will be automa�cally selected.
The 3RCI+ is also configured with the following Maximum Capaci�es for the Rhino Horn/Jib:
�
3M Rhino Horn/Jib is limited to 3400Kg.
�
5M Rhino Horn/Jib is limited to 1700Kg.
When a Rhino Horn/Jib is configured for use with
the 3RCI+ system, the following procedure needs to
be adhered to when attaching it to the machine.
�
Fit the Rhino Horn/Jib to the machine.
�
Ensure that the 3RCI+ System is turned off
and connect the Rhino Horn/Jib angle sensors
to the 3RCI+ CAN Bus at the end of the
Dipper arm.
�
Power on the system. The Rhino Horn/Jib will
be detected and the message shown here will
appear at startup.
�
Pressing OK will allow the system to continue
to the Operator Screen.