6
Functions
Opening
the door
Once the bath is drained, press the “door open” button (
D
) to al-
low the
person
to exit the bath.
Note:
In case of emergency, it is possible to open the door
even when the tub is full of water. Press the emer-
gency button “behind” the control panel (on the out-
side of the tub) and the door will open immediately
regardless of the water level.
Use this function only
in extreme situations!
Handling
the disinfection
If disinfection is installed, the “disinfection” button (
B
) will light
up in red after the
bath
is drained. Now take the red hand
shower (
S - pic. 6
) and press the “disinfection” button (
B
). The
button will turn green.
Now spray all internal tub surfaces with the disinfection solution.
In order to disinfect the hydro massage system hold the red
shower head directly
in
front of each massage nozzle and thus
route the disinfection solution into the nozzles. When finished
press the “disinfection” button (
B
) again. It will turn red.
After the prescribed contact time press the “shower” button (
H
)
and select maximum
temperature
. Now use the white hand
shower to rinse all disinfected parts thoroughly (also the mas-
sage nozzles as done before with the red hand shower). To com-
plete the procedure press the “shower” button (
H
) again. The hy-
dro massage jets will be turned on for a second.
Note:
During the whole disinfection procedure all other
functions are disabled. You can not fill the tub until
the disinfection procedure has been fully completed.
If the disinfection container is empty, the light is
flashing.
Flowmeter
The flowmeter is used to adjust the mixture ratio between water
and disinfectant. It is located next to the hose connector for the
disinfection on the outside of the bathtub. The table next to the
flowmeter (or else on the disinfectant container) should help you
to find the right values. Always follow the instructions of the dis-
infectant manufacturer. Usually the flowmeter is adjusted once
when the tub is installed.
Sleep
mode
If the
sit-in bathtub GK Hera
is left unused for over an hour, it
will go into sleep mode. In this case the temperature display (
M
)
shows three horizontal lines (– – –). Press any button on the con-
trol panel to reactivate it.
pic. 1
pic. 2
pic. 4
pic. 5
pic. 6
F
N
O
P
R
S
11
12
13
14
Summary of Contents for GK Hera
