Maintenance
49
Cod. 598144
Rev. 11/0717
14.6. Cleaning the drain pump
(Drain pump washers. Fig.14.3)
Only to be performed by the Authorised Technical Service
Required tools.
Disassembly of the lower front panel: Torx T25 screwdriver.
Before disassembling the lower front panel of
the
washing
machine,
disconnect
and
mechanically lock the external switch, and close
and mechanically lock the manual water inlet
valves.
Empty any residual water contained in the drain
ducts, placing the corrugated rear tube
horizontally on the floor. The water will come out
of the end.
Disassemble the lower front panel. The draining
pump is accessible.
Turn the filter counter-clockwise and separate it
from the pump body.
Clean the filter and any possible deposits from
the inside of the pump body.
Assemble the filter and the draining pump.
Replace the bottom panel.
Connect the external switch and open the
manual water inlet valves.
Begin a washing program and check that there
are no water leaks.
Fig.14.3
The bottom front cover is a stabilising element of the washer cabinet. Make sure that it is
properly mounted and fastened.
14.7. Checking the condition of the bearing housing seals
Only to be performed by the Authorised Technical Service.
At regular intervals check that no water is leaking out of the bearing drain pipe located at the back of the washer
at the bottom. Water loss indicates that the seals are in poor condition and need to be replaced.
14.8. General Overhaul
Only to be performed by the Authorised Technical Service
As preventive maintenance action, it is very important to request the Authorised Technical Service for a
periodic overhaul of the washing machine.
Recommended periodicity: every year or each
3000
washing cycles.
When performing this revision in models
HS-6008 / EH020,
due to the fatigue they are subject to, we
recommend carefully checking the door seal and replacing if wear is noticed.