Page 4 of 12
The GC154 may be operated by use of the UP/STOP/DOWN buttons on the side of the
unit (Fig. 1). The direction of travel of the motor can be reversed by using the Reverse
switch as indicated in (Fig. 2).
Fig.1
Fig.2
The GC154 may be programmed simultaneously with up to 20 Remote Controls or other
remote units. If an additional unit is programmed it will replace the last unit
programmed and the previous 19 units will remain unchanged.
The GC154 can operate in either Continuous or Step mode.
a.
In Continuous mode a single press of the button on the module or the Remote
handset will cause the Awning to move in the chosen direction until the limit
switch is actuated, unless the Stop button is pressed.
b.
In Step mode a single press will cause a small step in the chosen direction, but if
the button is not released within 2 seconds the movement will become
continuous as described above.
IN
STOP
OUT
REVERSE
PROGRAM
Summary of Contents for GC154
Page 7: ...Page 7 of 12 ...
