Setting the values for sun protection, twilight and temperature
Default setting:
Sun protection
3
approx. 20,000 Lux (7)
Twilight
2
approx. 40 Lux (8)
Temperature
°C
= Off (9)
o
Using a small screwdriver, adjust the values for sun protection
3
(7), twilight
2
(8) and if
necessary, the temperature
°C
(9), too.
In test operation, set the current brightness as sun protection threshold
The test operation makes it possible to adjust the sun protection and temperature threshold to
the currently prevailing conditions.
o
Press button
Prog
(3) briefly.
The sun sensor is in test operation for approx. 1 minute.
o
Turn adjuster
°C
(9) to left stop = Off.
LED lit up = Sun protection threshold undershot
LED flashing = Sun protection threshold exceeded
o
Turn adjuster
3
(7) slowly until the LED switches from illuminating to flashing.
The current temperature can also be applied now for temperature-dependent sun protection if
necessary.
i
The temperature threshold can only be set if the sun protection is not active.
o
Turn adjuster
°C
(8) slowly to the right until the LED switches from illuminating to flashing.
i
Pressing the button
Prog
(3) again exits test operation.
5 Information for electrically skilled persons
5.1 Fitting and electrical connection
Mounting of the sun sensor
To ensure good transmission quality, keep a sufficient distance from any possible sources of
interference, e.g. metallic surfaces, microwave ovens, hi-fi and TV systems, ballasts or
transformers.
Select the mounting location on the window pane in such a way that the sunlight can hit the
sensor without impediment even when sun protection is active. Shadows produce incorrect
measured values or prevent charging of the battery.
The contact surfaces of the sun sensor and the window pane must be clean and free of grease.
o
Moisten the suction pad slightly.
o
Place the sun sensor on the window pane and push it tight.
i
Metallised window panes can restrict the radio range greatly.
Dismantling the sun sensor
In order to avoid damage to the sun sensor, dismantling may only take place using the handle
(1).
o
Pull the handle (1) lightly to release the sensor from the window pane.
5.2 Commissioning
DANGER!
Electrical shock when live parts are touched.
Electrical shocks can be fatal.
During commissioning, cover the parts carrying voltage on radio transmitters
and actuators and in their surrounding area.
i
The energy store in the sun sensor is charged in the as-delivered state. Thus,
commissioning can take place even without putting the sun sensor in a light place
beforehand.
32582922
10864960
24.03.2017
3/7
Wireless Solar sun sensor
