Switch on test operation
The test operation is used for testing the detection area. In test operation, the device operates
independently of the brightness. All the other settings remain unchanged. Detected motions are
signalled by the blue status LED.
o
Press the
Test 100 h
button for between 4 and 10 seconds.
Test operation is switched on for 5 minutes.
i
By pressing the
ů
button of the IR remote control for end customers, you can
switch to automatic operation at any time (see Operation).
i
The function is also switched off if the
Reset
button is pressed for between 4 and
10 seconds.
Switch On for 100 h
This function is used to burn in fluorescent lamps.
o
Press the
Test 100 h
button for longer than 10 seconds.
The lamps are switched on for 100 hours. The device is switched back to automatic
operation again after the time has elapsed.
i
During the 100 hours, no switching is possible via 2-wire extension, installation button or IR
remote control, movement signals are not evaluated.
i
To switch off the function, press the
Reset
button for between 4 and 10 seconds.
Saving settings
Save the settings so that, if necessary, the end customer can recall them using the
Set 2
button. No values are saved in the as-delivered state.
o
Press the
Set 1
button for longer than 10 seconds.
The following settings are saved: Device function, sensitivity of PIR A-C, detection angle,
switch-on brightness, run-on time, dynamic run-on time, short-time operation, switch-off
prewarning. Previously saved values are overwritten.
Restoring the device to factory settings
o
Press the
Reset
button for longer than 10 seconds.
Function
Value
Device function
Motion detector
Operating mode
Automatic operation
Sensitivity of PIR A-C
100 %
Detection angle
360°, PIR A-C switched on
Switch-on brightness
10 lux
Run-on time
2 minutes
Dynamic run-on time
switched-off
Short time operation
switched-off
Switch-off warning
switched-off
Presence simulation
switched-off
Test operation
switched-off
i
If the
Reset
button is pressed for between 4 and 10 seconds, only a few functions are
terminated (see button assignment of Installation engineer IR remote control).
6 Appendix
82593212
12.01.2017
15/18
Presence detector and motion detector 360° compact
