Giordani orion 012, Owner'S Manual

Page: 15 / 40

14 15
6. Base
7. Blue lock-off clip (for rearward
facing use only)
8. Infant reducer cushion (some
models only)
9.
Adjustable headrest
10. Diagonal belt guides (x2 - for
rearward facing use only)
11. Red belt lock-off (x2 - for diagonal
belt (forward facing use only)
12. Lap belt guides (x2 - for forward
facing use only)
13.
Lap belt guides
(x2 - for rearward
facing use only)
14. Seat reclining lock
adJUSTinG THE HarnESSES
Make sure that the harness of your
car seat is adapted to the height of
your child before starting to install
the seat in your car. The height of the
headrest and the harness can be ad-
justed simultaneously, they should
be positioned just above the shoul-
der of the child. Loosen the wheel
on the head support (2), adjust the
head support to the desired height
(3), then tighten the wheel (4).
THE CorrECT TYPE oF SaFETY
BELT To USE WiTH YoUr Car SEaT
Your car seat must ONLY be installed
on a passenger seat fitted with a
3-point safety belt. NEVER install
your car seat on a passenger seat
fitted with a 2-point safety belt! (i -
0-10 kg) (i - 9-25kg)
rEarWard FaCinG USE
(0 - 10 KG)
DO NOT USE THIS CHILD SEAT ON
A PASSENGER SEAT FITTED WITH A
FRONT AIR BAG! When used rear-
ward facing, the child seat must be
in the fully reclined position.
Pull lap and diagonal sections of
the car seat belt until fully extended
and feed both through the space be-
tween the shell and the base. Fasten
the seat belt. Thread the lap section
through the guides located at the
front of the base (5). Thread the di-
agonal strap through the two upper
guides located on the back of the
seat shell (6). Tighten the seat belt
by pulling first on the lap section,
then on the diagonal one (7). Check
that there are no kinks or twists in
the seat belt. Lock the 2 sections of
the belt with the blue lock-off clip.
The lock-off should be positionned
against the buckle of the seat belt
(8). Do not use the red lock-off for
the rearward facing installation. Al-
ways keep the seat in the most re-
clined position.
ForWard FaCinG USE
(9-18 KG)
It is not recommended to fit the
child car seat into a front seat
equipped with airbag. If you wish
to fit the child car seat in any seat
protected by airbag, always refer to
the vehicle instructions manual.
Fully recline the seat. Pull lap and di-
agonal sections of the car seat belt
until fully extended and feed both
through the space between the
shell and the base. Fasten the seat
belt
(9).
Thread the lap section through the
guides located below the 2 red lock-
off clips. Open the 2 red lock-off clip
next to the buckle, then route the di-
agonal section of the belt through
the open lock-off clip (10). Push the
child seat right down into the car
seat, and tighten both sections of
the seat belt by pulling the belt in the
direction shown (11). Close the lock-
off across the diagonal belt. Check
that there are no kinks or twists in
the seat belt (12).
HarnESS BUCKLE
To fasten the harness, bring the two
shoulder straps together (13) (14)
and insert them into the buckle; you
should hear a “click” (15). To release
the harness, press the buckle’s red
button
(16).
FiTTinG THE HarnESS
• To tighten the harness: Pull on the
adjusting straps positioned on
the harness. You do not need to
press on the adjuster buttons (17).
IMPORTANT: A correctly adjust-
ed harness is essential for your
child’s protection. There should
not be more than finger’s width
between the harness and your
child.
• To loosen the harness: Press on the
adjuster buttons positioned on the
upper section of the harness, grasp
the lower section and pull simulta-
neously (18).
rEMoVinG THE HarnESS
Undo the harness if necessary (19).
Position the harness strap behind
the central section of the seat cov-
er (20). Repeat the operation on the
second harness strap. The harness
straps should be hidden under the
central of the cover (21). Remove the
crotch strap by twisting the metal
keeper and by passing it through the
slots in underneath the plastic base
and the cover (22). Simply reverse
this procedure if you want to re-in-
stall the harness of your car seat.
ForWard FaCinG USE
(Gr.2 FroM 15 To 25 KG)
It is not recommended to fit the
child car seat into a front seat
equipped with airbag. If you wish to
fit the child car seat in any seat pro-
tected by airbag, always refer to the
vehicle instructions manual.
Make sure that you have removed
the harness of the car seat before
starting the installation. Follow the
instructions in the section entitled
‘Removing the harness’. The car
seat must be set in its most up-
right position. Place the car seat in
a front-facing position on the rear
passenger seat of your vehicle and
sit your child in the car seat. Pull on
the seat belt until it is completely
loose. Thread the seat belt through
the openings on the side of the shell
and cover of the car seat
(23). Pull
on the belt and threaded through the
openings on the opposite side of the
shell and cover (24). Fasten the seat-
belt (25). On the side nearest the
belt winder, pull up the diagonal belt
through the slot located on the side
of the shell (26). Make sure the belt
is not twisted and pull it as tightly as
possible (27). Check that the diago-
nal lies across your child’s shoulder,
clear of its neck.
rECLininG YoUr CHiLd SEaT
Push the adjustment lever located
under the front of the seat upwards,
then pull or push the base towards or
away from you (28).
GR285_ORION 012_70%.indd 15 19/10/18 16:56