GinSan SGS327, Quick Start Manual

Page: 4 / 4

1
2
3
4
5
5
6
7
9
8
7A
1206 0894 GS
17003T 17005T
Key Part 17002T 1 HP 17895T 1-1/2 HP
No. Description Qty. 1 HP 3 PHASE 1-1/2 HP 3 PHASE
1 Motor 1 AE100EH2 AP100FL-T AP100GL2 AP100GL-T
2 3/8-16x1-1/4 Hex Cap Screw 4 U30-982ZP U30-982ZP U30-982ZP U30-982ZP
3 Slinger 1 17351-0009 17351-0009 17351-0009 17351-0009
4 Pump Body 1 C2-85 C2-85 C2-85A C2-85A
5 O-Ring 2 U9-430 U9-430 U9-430 U9-430
6 Shaft Seal 1 U109-118 U109-118 U109-118 U109-118
7 Stack* 1 P325-788R P325-788R P325-789R P325-789R
7A Nylatron Bearing 1 W31112R W31112R W31112R W31112R
8 Pump Shell 1 P56-469SSL P56-469SSL P56-434SSL P56-434SSL
9 Discharge 1 C152-3 C152-3 C152-3A C152-3A
Repair Parts List
* Includes Key Nos. 5 and 7A.
4
C. Lubricate outside rubber surface of seat with soapy
water. Place cardboard washer over polished face of
seat and press into seal cavity using a 3/4” socket or
a piece of 3/4” standard pipe.
D. Be sure polished surface of seat is free of dirt and has
not been damaged by insertion. Re-move excess
soapy water. Dispose of card-board washer.
11. Installation of rotating half and spring:
A. Reinstall pump body on motor using extreme caution
not to hit ceramic portion of seal on motor shaft.
Reattach pump body to motor using capscrews.
B. Inspect shaft to make sure that it is clean.
C. Clean face of rotating half of seal with a clean cloth.
D. Lubricate inside diameter of rotating half with soapy
water and slide onto motor shaft (sealing face first).
E. Place spring over motor shaft so it rests on rotating
half.
12. To complete reassembly from this point, reverse
instructions 1 through 5 under “Impeller Stack
Changeout.”
NOTICE: Lubricate suction and discharge O-Rings with
soapy water for easier installation of shell.