Final Installation
1. Attach the vacuum’s hose to the vacuum tank and then the hose to the separator tank.
2. Cut the hose to the needed length and attach one of the 1 1/4” swivel cuffs to one
end of the vacuum hose.
3. Attach the hose cuff to the input tube labeled “Hose from vacuum”.
4. Attach another 1 1/4” swivel cuff to one end of the 1 1/4” X 25’ vacuum hose.
5. Attach the cuff to the input tube labeled “Hose from wash bay”.
6. Route the hose from the separator tank to the hole drilled though the wall that leads to
the washtub area (must be within 14’ of the tank).
7. Run the vacuum hose through the wall and cut to desired length (if needed).
8. Attach the final swivel cuff to the end of the vacuum hose.
9. Attach the grooming tool to the hose cuff.
10. Attach the 24 VAC activation wire to one of the terminals on the relay controlled
outlet.
11. Attach a 24 VAC common wire to the other terminal on the relay controlled outlet
box.
12. Plug the vacuum into the relay controlled outlet box.
13. Plug the relay controlled outlet box into the GFI outlet.
14. Turn the switch on the vacuum unit into the “on” position.
15. Install the strainer basket into the separator tank and install the tank lid’s latching
ring.
9
