OPERATING INSTRUCTIONS
BEFORE FIRST USING YOUR APPLIANCE
1. Read all instructions in this manual before using your digital 10 in 1 oven.
2. Make sure that the oven is unplugged.
3. Wash all the accessories in hot, soapy water or in the dishwasher. Also remove the
protective film on the control panel.
4. Thoroughly dry all accessories and re-assemble in oven according to your needs.
5. Plug oven into the electrical outlet. The LED display panel will illuminate and the
oven will beep once to advise you that it is plugged in.
6. After re-assembling your oven, we recommend that you run the oven at the highest
temperature on the BAKE function for approximately 30 minutes to eliminate any
packing residue that may remain after shipping. This will also remove all traces of odor
initially present.
·
Close the door and press the “BAKE&TOAST” button to select BAKE mode.
·
Use the “INCREASE” button to select the highest temperature which is 450°F.
·
Then press the “TIMER” button to set the time and use the “Increase” or
“Decrease” button to select 30 minutes time.
·
Once the time is set, press the “Start” button.
·
The clock on the LED display will show the time counting down. The oven will
beep eight (8) times to signal the end of the cycle and the word “END” will appear
flashing on the LED display.
Note
- Initial start-up operation may result in minimal smell and smoke (about 15
minutes). This is normal and harmless. It is due to burning off of the protective
substance applied to the heating elements in the factory.
www.Ginnys.com
USING YOUR OVEN
1.
Place oven on a heat-resistance stable surface.
2.
Connect the power supply.
3.
Place food onto the roast / bake rack or roasting tray or rotisserie rotating set. Be
sure to use cotton twine to tie poultry leg and wings to avoid food touching
heating elements.
4.
Press the function button to select your desired mode.
5.
Set your desired temperature.
6.
Set the timer and press “START” button to begin cooking.
7.
The oven will beep eight(8) times to signal the end of the cooking cycle and the
word “END” will appear flashing on the LED display. Press the “PAUSE/CANCEL”
button to clear the display. Now you can take the food out with the appropriate
utensils. The word “END” will disappear after about 5 minutes.
8.
Unplug the appliance when finished using.
9.
The default showing of LED display is time. During the cooking cycle, you can
change the time or temperature. Press “TIMER” button and use “INCREASE” or
“DECREASE” button to reset the time. To change the temperature during a
cooking cycle, press the “TEMP” button and the LED display will let you see the
already set temperature. You can now change the temperature by pressing the
“INCREASE” or “DECREASE” button or do not do anything and the display will go
back to showing the time after about 15 seconds.
10. The program is already set to preheat the oven automatically in the modes of
ROAST, BAKE, BROIL and GRILL/GRIDDLE. Once you select these modes, the
oven will be preheated to the desired temperature first. When preheating
completed, the oven will beep and keep one minute. Now you can put your food
in the oven, press” START” to begin cooking and the clock on the LED display will
show the time counting down. If you do not do anything in 5 minutes after
preheating is ready, the oven will auto cancel the operation and clear the display.
www.Ginnys.com
7 8
Summary of Contents for TL-1028RF-AQ
Page 3: ......
