Gin Pegasus 3, User Manual, Page: 14 / 52

a
Pegasus 3 user manual
aa
_______________________________________________________________________________________________________________________________
a
a
Flying the Pegasus 3
a
The
fl
ight practice for motorized operation and free
fl
ying is identical in many respects.
Therefore, they are considered together in this manual. Differences and special features are
indicated either directly or in the description of the respective operating mode.
Gin Gliders cannot ensure that the fl ight behavior described in this chapter is accurate to all
engines used with the Pegasus 3. The compatibility of a new combination must therefore be
con fi rmed by a test fl ight by an accredited K-pilot. Compatibility fl ights can be requested by the
manufacturer of the engine or in the form of a single sample test by the pilot himself at a testing
house.
Preparation for launch
a
Follow a consistent routine every time you
fl
y. This is very important for safety. We recommend
the following procedure:
}
Check the following condition of your paraglider and other fl ying equipment before every fl ight:
●
Is the glider fabric free from tears or other damage?
●
Are the lines free from knots, tangles or other damage?
●
Are the brake lines freely and fi rmly connected to the handle?
●
Is the brake line length correctly adjusted?
●
Are the maillons connecting the lines and risers closed and secured?
●
Is the glider dry?
●
Are the risers and carabiners in good condition?
●
Is your harness in good condition?
●
Is your rescue handle secure and rescue pin in?
}
}
A careful pre- fl ight check is required for any type of aircraft. Make sure that you exercise the
same level of care each time carry out the check.
●
Once you have arrived at the take-off, you should fi rst take a look at the conditions:
observe wind speed and wind direction, airspace, turbulence and thermal cycles.
●
Check your engine, paraglider, harness, rescue handle and pin, helmet and other
equipment.
●
Carry out the pre fl ight control check of the engine.
●
Choose a wide starting place, as uniform as possible and free from obstacles.
●
Put on your harness and be sure to close the leg straps! Then put on your helmet.
●
Place the paraglider in a curved shape and sort the lines.
●
Connect the riser to the harness carabiners. Make sure that the carabiners are closed
and that nothing is twisted.
●
Connect the speed system of the riser and harness with the Brummel hooks.
ǧ
ǧ
ǧ
ǧ
Page 14
a