background image

12

 

Notice: 

Under Body-Object-switch for “Body temp” Mode, the body tempera-

ture memories display;

  Under Body-Object-switch for “Object temp” Mode, the object temperature 

memories display;

Battery Replacement

•  When the low battery symbol 

 appears in the display, replace the meter’s  

battery. The battery compartment is located on the bottom of the handle. Press 

down on the battery compartment lock and at the same time slide the battery 

compartment downwards. Replace the (2) “AA” batteries and close the battery 

compartment cover.

  You, as the end user, are legally bound (Battery ordinance) to return all used 

batteries and accumulators; disposal in the household garbage is prohibited! 

You can hand over your used batteries / accumulators at collection points   

in your community or wherever batteries / accumulators are sold!

Disposal

: The product must not be disposed of along with other do-

mestic waste. The users must dispose of this equipment by bringing it 

to a specific recycling point for electric and electronic equipment. For 

further information on recycling points contact the local authorities, the 

local recycling center or the shop where the product was purchased. 

If the equipment is not disposed of correctly, fines or penalties may 

be applied in accordance with the national legislation and regulations.

IR Measurement Notes

• Before measuring, be sure to clean surfaces that are covered with frost, oil, 

grime, etc.

•  If an object’s surface is highly reflective, apply masking tape or flat black paint 

to the surface before measuring. Allow time for the paint or tape to adjust to the 

temperature of the surface it is covering.

•  Measurements through transparent surfaces such as glass may not be accurate.

•  Steam, dust, smoke, etc. can obscure measurements.

• The meter automatically compensates for deviations in ambient temperature. 

However, it can take up to 30 minutes for the meter to adjust to extremely wide 

changes.

Specifications

ENGLISH

Range

Accuracy

Body Temp

35.0 to 42.0°C (95.0 to 107.6°F)

±0.2°C / ±0.4°F

In the remaining measurement range

±0.3°C /± 0.5°F

Object Temp

0 to 100.0°C (32.0 to 212.0°F)

±1.0°C / ±1.8°F

Summary of Contents for YI-400









Reviews: