GILMAN Gemini GMFH15W, Manual

Page: 6 / 15

6
CLEAN & STORAGE
TIP-OVER AUTO-OFF SAFETY SYSTEM
• Your appliance must be switched OFF and disconnect to the main power supply
and unplugged before proceeding with any cleaning work.
• Clean the housing with a lightly damp cloth of the appliance.
• Never use flammable or abrasive cleaning agents such as benzene or spirit to
clean the appliance.
• Never immerse the appliance in water!
• Clean the air outlet regularly.
• If the appliance is not used for an extended period it must be protected against
excessive dust and dirt. Please pack the appliance and store in a dry place away
from sunlight and dirt.
• Clean the Absorbent cotton (Page 4. Item 14): Suggest replace every 3 to 6 months.
Open the water tank cover, take out the absorbent cotton sleeve & absorbent
cotton if scale and dirties on the surface of the absorbent cotton, it can be washed
with water or washed with citric acid.
When appliance inclines from vertical or tip-over, it will stop working. When appli-
ance is returned to upright position, it can connect the power again and returns to
standby mode, set the desire setting to start operating again. Do not use on thick
and long pile carpet, as the appliance may not work due to the tip-over switch not
been activated.
and install in the appliance, turn it on again or in the standby state, after accumulating
to 72 hours, the 72-hour cleaning reminder function will be automatically activated.
Remark when the main power or tip-over switch were disconnected , the 72 hours
will be recovered.
This appliance uses intelligent timing or water tank without water reminder to add
water; every time you start spraying, the countdown starts, and continuous spraying
for 6 hours or water tank without water will automatically remind you to add water.
When entering the reminder, the buzzer will sound “beep beep beep” , then the mist
indicator flashes and the mist function is turned off; before adding water, please push
power button of the control panel to turn off the appliance. After adding water to reset,
you need to press mist button again to enter the mist function.
12. OSC button : press this button when the appliance is on, the OSC indicator will
light up and OSC function will start. Press this button again, the OSC function is
closed.