25
Using a handset as a room monitor (Babyphone)
Gigaset SL610H PRO / GBR / A31008-M2352-R101-2-PG43 / registr_sett.fm / 24.08.2012
V
e
rsion 4,1, 21
.11.2007
The wake-up call sounds for 60 seconds. If
no key is pressed, the wake-up call is
repeated twice at five minute intervals and
then switched off.
During a call, the wake-up call is only sig-
nalled by a short tone.
Deactivating the wake-up call/
repeating after a pause (snooze
mode)
Prerequisite
: A wake-up call is sounding.
§OFF§
Press the display key. The wake-
up call is deactivated.
or
§Snooze§
Press the display key or any key.
°
is shown in the display. The
wake-up call is deactivated and
then repeated after 5 minutes.
After the second repetition, the
wake-up call is deactivated
completely.
Using a handset as a
room monitor
(Babyphone)
If the room monitor is activated, a previously
saved destination number is called as soon
as a set noise level is reached. You can save
an internal or external number in your hand-
set as the destination number. All of the
handset keys are deactivated, with the
exception of the display keys.
The room monitor call to an external
number is terminated after approximately
90 seconds. The room monitor call to an
internal number (handset) stops after
approx. 3 minutes (depending on the base).
When the room monitor is activated, all keys
are locked except the end call key. The hand-
set's speaker can be switched on or off (
Two
Way Talk
=
On
or
Off
). If
Two Way Talk
is
switched on, you can answer the room
monitor call.
Activating the room monitor and
entering the destination number
v
¢
É
¢
Room Monitor
¤
You can enter data in the following fields:
Activation:
Select
On
to activate.
Alarm to:
Select
Internal
or
External
.
External number:
Select the number
from the directory (press display key
ö
)
or enter it manually.
Internal number:
Select display key
§Change§
¢
Select handset or
Call All
to
call all registered handsets
¢
§OK§
.
In idle status, the destination number or
the internal destination number is dis-
played.
Two Way Talk:
Switch the handset's speaker on or off
(select
On
or
Off
).
Sensitivity:
Select noise level sensitivity (
Low
or
High
).
¤
Press
§Save§
to save the settings.
Warning!
u
Always check the operation of the
room monitor before use. For exam-
ple, test its sensitivity. Check the
connection if you are diverting the
room monitor to an external
number.
u
When the function is switched on, the
handset's operating time is considera-
bly reduced. If necessary, place the
handset in the charger. This ensures
that the battery does not run down.
u
Ideally the handset should be posi-
tioned 1 to 2 metres away from the
baby. The microphone must be
directed towards the baby.
u
The connection to which the room
monitor is diverted must not be
blocked by an activated answering
machine.
