9
User manual Athens/China C360,C365 English
Appendix
Entering special characters
Standard characters
Specifications
Recommended battery pack
(Valid at the time of going to press)
Nickel-metal-hydride (NiMH):
Handset C36H: V30145-K1310-X359, X402
The handset is supplied with the recommended
battery pack.
Base station power consumption
In standby mode: approx. 2W
During a call: approx. 3W
General specifications
Care
◆
Wipe the base station and handset with a
damp
cloth (no solvents) or an antistatic cloth.
Never
use a dry cloth. This can cause static.
Contact with liquid
If the handset has come into contact with liquid:
◆
Switch off the handset and remove the bat-
tery pack immediately.
◆
Allow the liquid to drain from the handset.
◆
Pat all parts dry, then with the battery compart-
ment open and the keypad facing down place
the handset in a dry, warm place
for at least
72 hours
(
not
in a microwave, oven etc.).
◆
Do not switch on the handset again until it is
completely dry.
When it has fully dried out, you will normally be
able to use it again.
Questions and answers
If you have any queries about the use of your
phone, you can contact us any time at
www.siemens.com.cn/shc. Or
Call hotline: 4006 706 007
The table below contains a list of common
problems and possible solutions.
1x
2x
3x
4x
5x
6x
1
Space
1 £ $ ¥ ¤
Q
.
,
?
!
0
+
P
* /
(
)
<
=
#
Abc-->
123
123-->
abc
#
@
\
&
WDCT standard
is supported
Range
up to 300 m outdoors,
up to 50 m in buildings
Base station power supply 230 V ~/50 Hz
Environmental conditions
in operation
+5 °C to +45 °C;
20% to 75% humidity
!
Problem
Cause
Solution
Nothing
appears in the
display.
The handset is not
switched on.
Battery pack is
flat.
Press the end call key
a
for
approx. 5 sec.
or place the handset
in the base station.
Charge/replace the
battery pack (page 3).
No reaction to
keystroke.
The key lock is
activated.
Press the hash key
R
for
approx. 2 sec.
(page 1).
No wireless
connection to
the base sta-
tion,
Base
flashes in the
display.
The handset is
outside the range
of the base sta-
tion.
The handset is not
registered.
The base station is
not switched on.
Cords not routed
correctly
Move the handset
closer to the base
station.
Register the handset
(page 3).
Check the power con-
nector at the base sta-
tion (page 2).
Check cord routing
(page 2).
