46
www.gigamedia.net
EN
[NTP setup]
The NTP server must be installed in the PC.
Host computer IP:
Input the IP address installed NTP server.
Port:
Default: 123. You can set the port according to NTP server.
Time zone:
London GMT+0, Berlin GMT +1, Cairo GMT +2, Moscow GMT +3, New
Delhi GMT +5, Bangkok GMT +7, Hongkong Beijing GMT +8, Tokyo GMT +9, Syd-
ney GMT +10, Hawaii GMT-10, Alaska GMT-9, Pacific time GMT-8, American
mountain time GMT-7, American mid time GMT-6, American eastern time GMT-
5, Atlantic time GMT-4, Brazil GMT-3, Atlantic mid time GMT-2.
Update cycle:
The same with the NTP server check interval. Default: 10 minutes.
[DDNS]
It is the abbreviation of dynamic domain name server.
Local domain name:
Provide the domain name registered by DDNS.
Server domain name:
Provide the domain name of DDNS.
Port:
Provide the visit port number of DDNS.
User name:
Provide the account registered by DDNS.
Password:
Provide the password registered by DDNS.
When the DDNS is successfully configured and start, you can connect the domain
name in the IE address column to visit.
Note:
The DNS setup must be configured correctly in the network setup.
[IP purview setup]
When choosing the white list, only the listed IP address can connect the DVR.
The 64 IP addressed are supportive in the list.
When choosing the black list, the listed IP address can not connect the DVR. The
64 IP addressed are supportive in the list.
You can delete the set IP address by √ in the options.
Note: When the same IP address is in the white and black list at the same time,
the black list precedence is higher.
[Email setup]
If the alarm is turned on or the alarm linkage photos are taken, send an email about
the alarm information and the photos to appointed address.
SMTP server:
Email server address. It could be an IP address or domain name.
Domain name can be translated only it is the correct DNS configuration.
Port:
Email server port number.
SSL:
Decide whether using Secure Socket Layer protocol to login.
User:
Apply the email server user name.
Password:
Input the password corresponding to the user.
Sender:
Set the email sender address.
Receiver:
Send the email to appointed receivers when the alarm is turned on.
You can set three receivers at most,and each receiver separate by “; ”(Semicolon
+ Space), receiver and sender can use same email.
Subject:
You can set as you wish.
Image 4.10 Création DDNS
Picture 4.7 NTP setup
Picture 4.8 Email setup
Picture 4.9 IP purview setup
