Western Digital NIC Configuration
- 26 -
4-3 Adapter Board LEDs
LEDs on the Onyx bulkhead indicate various board state and activity.
•
•
LEDs labeled “1” and “2” indicate Ethernet lane activity.
• The LED labeled ‘F’ indicates the firmware state.
•
The LED labeled ‘H’ indicates hardware and management state.
4-3-1 Firmware State LED
The following table describes the meaning of the “F” or FW State LED. Please note that solid fields in this
table define a solid (non-blinking) LED state.
LED: F
Stage
Controlled by
Amber
Boot sequence started
boot
Amber
This SPI flash device contains the firmware (FW)
that Fuji requires to run.
FW
Green
*Recovery/Golden Image Booted – FW will Blink
the Amber LED while the Recovery Image is
running during normal operation
FW
Amber
*Action Required (AR) Condition
FW
Red
Reset button has been depressed
FW
Green
Release Reset button to clear configuration
FW
*Blink rate is once per second
NOTE!
•
A sustained solid Amber indicates that the adapter must be shipped back to the factory (also known as a
“bricked” state.)
•
This includes Power-On SelfTest (“POST”) failure.
•
FW change to blinking Amber if Attention Required (“AR)”. Example causes:
•
Booted to Golden RTL
