Gigabyte R451-3R0, User Manual

Page: 71 / 117

- 71 - BIOS Setup
Port Level Configuration
Press [Enter] to configure advanced items.
Š
Link Speed
– Allows for automatic link speed adjustment.
– Options available: Auto Negotiated/1 Gbps/10 Gbps/SmartAN.
Default setting is Auto Negotiated .
Š
Boot Mode
– Select the preferred boot protocol or disable.
– Options available: PXE/Disabled. Default setting is PXE .
Š
DCBX Protocol
– Enables/Disables DCB Protocol.
– Options available: Disabled/IEEE/CEE/Dynamic. Default setting is
Dynamic .
Š
RoCE Priority
– Enter desired RoCE Priority within a range of 0 to 7
Š
PXE VLAN Mode
– Configure virtual LAN mode.
– Options available: Enabled/Disabled. Default setting is: Disabled .
Š
Link Up Delay
– Maximum amount of time in seconds UEFI or Legacy driver will
wait for Management FW to bring-up the link.
Š
RDMA Protocol Support
– Specifiy which Remote Direct Memory Access Protocol is to be
used.
– Options available: None/RoCE/IWARP. Default setting is: RoCE
Partition Mode
Select the desired port partitioning mode.
Options available: Default/NPAR. Default setting is:
Default
Device Name
Displays the technical specifications for the Network Interface Controller.
Chip Type
Displays the technical specifications for the Network Interface Controller.
PCI Device ID
Displays the technical specifications for the Network Interface Controller.
PCI Address
Displays the technical specifications for the Network Interface Controller.
Link Status Displays the technical specifications for the Network Interface Controller.
Link Speed
Displays the technical specifications for the Network Interface Controller.
Permanent MAC Address
Displays the technical specifications for the Network Interface Controller.
Virtual MAC Address
Displays the technical specifications for the Network Interface Controller.