Gigabyte GA-8ID2003, User Manual

Page: 54 / 96

- 50 - GA-8ID2003 Series Motherboard
English
Set Supervisor/User Password
When you select this function, the following message will appear at the center of the screen to
assist you in creating a password.
Type the password, up to eight characters, and press <Enter>. You will be asked to confirm the
password. Type the password again and press <Enter>. You may also press <Esc> to abort the
selection and not enter a password.
To disable password, just press <Enter> when you are prompted to enter password. A message
"PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password is
disabled, the system will boot and you can enter Setup freely.
The BIOS Setup program allows you to specify two separate passwords:
SUPERVISOR PASSWORD and a USER PASSWORD. When disabled, anyone may access all
BIOS Setup program function. When enabled, the Supervisor password is required for entering the BIOS
Setup program and having full configuration fields, the User password is required to access only basic
items.
If you select "System" at "Password Check" in Advance BIOS Features Menu, you will be
prompted for the password every time the system is rebooted or any time you try to enter Setup Menu.
If you select "Setup" at "Password Check" in Advance BIOS Features Menu, you will be prompted
only when you try to enter Setup.
Figure 12: Password Setting
CMOS Setup Utility-Copyright (C) 1984-2003 Award Software
} Standard CMOS Features Top Performance
} Advanced BIOS Features Load Fail-Safe Defaults
} Integrated Peripherals Load Optimized Defaults
} Power Management Setup Set Supervisor Password
} PnP/PCI Configurations Set User Password
} PC Health Status Save & Exit Setup
} Frequency/Voltage Control Exit Without Saving
ESC:Quit higf :Select Item
F8: Q-Flash F10:Save & Exit Setup
Change/Set/Disable Password
Enter Password:
8id2003_2002_b.p65 2003/3/14, 上午 11:33 50