A-2: Installation in Intel RST Premium With Intel Optane System Acceleration mode
If the SATA controller has been configured in Intel RST Premium With Intel Optane System Acceleration mode,
please follow the steps below:
1. After system restarts, go to the BIOS Setup, make sure
CSM Support
under the
Boot
menu is disabled.
2. Go to
Settings\IO Ports\SATA And RST Configuration
and make sure
USE RST Legacy OROM
is disabled
and
RST Control PCIe Storage Devices
is set to
Manual
. If you want to enable the Optane
™
memory installed
in the M.2 connector, set
PCIe Storage Device on Port 21
to
RST Controlled
.
3. Enter the operating system, launch the Intel
®
Rapid Storage Technology utility from the Start menu, and then
enable Intel
®
Optane
™
Memory on the
Intel
®
Optane
™
Memory
screen.
4. Launch the
Intel
®
Rapid Storage Technology
utility from the Start menu and make sure the Intel
®
Optane
™
Memory has been enabled. If you want to accelerate the system drive, you can select specific folders, files, or
applications to accelerate using the
Intel
®
Optane
™
Memory Pinning
function. (The Intel
®
Optane
™
memory
used must have at least 32 GB capacity.)
•
An Optane
™
memory cannot be used to accelerate an M.2 PCIe SSD.
•
Do not abruptly remove the Optane
™
memory. Doing so will cause the operating system to stop
functioning correctly.
•
If you want to change/remove the Optane
™
memory, you must disable it using the Intel
®
Rapid
Storage Technology or Intel(R) Optane
™
Memory application first.
•
After enabling the Optane
™
memory, the related BIOS settings will remain even after a BIOS update.
- 40 -
