Install the RAID driver and operating system
With the correct BIOS settings, you are ready to install the operating system.
Installing the Operating System
As some operating systems already include RAID driver, you do not need to install separate RAID driver during
the Windows installation process. After the operating system is installed, we recommend that you install all
required drivers from the motherboard driver disc using "Xpress Install" to ensure system performance and
compatibility. If the operating system to be installed requires that you provide additional RAID driver during the
OS installation process, please refer to the steps below:
1. Copy the
IRST
folder under
\Boot
in the driver disc to your USB thumb drive.
2. Boot from the Windows setup disc and perform standard OS installation steps. When the screen requesting
you to load the driver appears, select
Browse
.
3.
Then browse to the USB flash drive and select the location of the driver. The location of the driver is as
follows: \IRST\f6flpy-x64
4. When a screen as shown, select
Intel(R) Chipset SATA/PCIe RST Premium Controller
and click
Next
to
load the driver and continue the OS installation.
(Note) If the system already has Intel
®
Rapid Storage Technology utility installed, you have to remove it first
before installing the Intel(R) Optane(TM) Memory System Acceleration application.
3-2 Installing an Intel
®
Optane
™
Memory
System Requirements
1. Intel
®
Optane
™
memory
2. The Optane
™
memory must have at least 16 GB capacity, and it must have equal or smaller capacity than
the hard drive/SSD to be accelerated.
3. The Optane
™
memory cannot be used to accelerate an existing RAID array; the accelerated hard drive/SSD
cannot be included in a RAID array.
4. The hard drive/SSD to be accelerated must be a SATA hard drive or M.2 SATA SSD.
5. The hard drive/SSD to be accelerated can be a system drive or data drive. The system drive must be GPT
formatted and have Windows 10 64-bit (or later version) installed on it. The data drive must also be GPT
formatted.
6. The motherboard driver disc
Installation Guidelines
A-1: Installation in AHCI mode
If the SATA controller has been configured in AHCI mode, please follow the steps below:
1. After entering the operating system, insert the motherboard driver disc into your optical drive. On the
Xpress
Install
screen, select
Intel(R) Optane(TM) Memory System Acceleration
(Note)
to install. Follow the on-screen
instructions to continue. When completed, restart the system.
2. After re-entering the operating system, follow the on-screen instructions to complete the settings, and then
the
Intel
®
Optane
™
Memory
application will appear automatically. All data on the Optane
™
memory will be
erased. Make sure you back up the data before continuing. Follow the on-screen instructions to proceed.
When completed, restart the system.
3. Launch the
Intel
®
Optane
™
Memory
application from the Start menu and make sure the Intel
®
Optane
™
Memory has been enabled. (The SATA controller mode is changed to "Intel RST Premium With Intel Optane
System Acceleration" from AHCI mode. DO NOT change your SATA controller mode back to AHCI. Doing
so will cause the Optane
™
memory unable to function properly.)
4.
If you want to accelerate the system drive, you can select specific folders, files, or applications to accelerate
using the
Intel
®
Optane
™
Memory Pinning
function. (The Intel
®
Optane
™
memory used must have at least
32 GB capacity.)
- 39 -
