Page
13
of
56
USE AND MAINTENANCE MANUAL
Code MUT 088
Rev. 1
The tubular motors are single-phase asynchronous irreversible equipped with thermal
protection at 140°C for safety devices against overheating. They are equipped with a
condenser, electromechanical brake assembly, two limit switches and mechanical scaler for the
reduction of primary turns at 12 or 17 [rev/min] ouputs.
The type of engine used on the awnings is indicated in the product sheet.
ELECTRICAL COMPONENTS
3.2
CAUTION: MOTOR REDUCERS have degree of protection IP 44, watertight and are
in insulation class 1 (compulsory grounding).
IMPORTANT: The instructions specific for engines are supplied upon delivery of
the awning. These instructions must be read carefully, annexed to this manual and
keep in good condition for any subsequent consultation by the customer.
Declarations of Conformity of the engine can be found in the restricted areas of
the sites supplying them.
ELECTRONIC COMPONENTS OF THE AWNING (OPTIONAL)
3.3
Upon optional request the awning can be managed electronically in its functions with control
of the weather conditions. In this case, the awning can be fitted with the following additional
electronic devices: automatic control unit for wing or automatic control unit of sun and wing or
rain gauge (see par. 2.3).
The type of electronic component used on the awning is indicated in the product sheet.
CAUTION: Never set the wind speed above the wind resistance of the awning itself
(maximum threshold recommended for MEDISOLAFLY R: 40 Km/h).
Response time:
• Detection of the wind :
3 seconds after up command.
• Presence of sun :
2 minutes after down command.
• Disappearance of the sun :
15 minutes after up command.
ATTENTION!: Corrosion resistance is not guaranteed in the event of immersion or
sprays with salt water (sea storms, etc.). Also, with intense exposure to salty fog,
incrustations or bubbles could appear in the connections or aluminium profiles
and oxide or rust could appear on the stainless steel brackets. These conditions
are not covered by warranty.
The aluminium casts are in EN AB 46100 and EN AB 44100 alloys.
The casted components for the sliding carriages, pulleys and other plastic components are
made from fiberglass reinforced nylon or Ryton
®
PPS. Toothed belt with steel strands. Stainless
steel screws.Stainless steel plates.
IMPORTANT: The specific installation, use and maintenance instructions of the
units are attached to the packaging of the units themselves, delivered with the
awning. These instructions must be read carefully, attached to this manual and
kept in good condition for future reference on part of the customer.
www.gibus.com
Summary of Contents for MED OPEN FLY
Page 2: ......