22
23
SNAPPER
SNAPPER
UK
UK
If the gate needs to be operated manually because of a power failure or operator malfunctioning:
Insert the release key to the release slot
fig. 7
.
Turn the release key
.
Pull out the release bar and keep it pulled out
.
Move the gate manually only in the event of a power failure.
UNLOCKING DEVICE
If you need to install an electric lock, refer to figures
11
and
12 .
1) ELECTRIC LOCK
2) ELECTRIC LOCK FASTENING PLATE
3) BUSHING
4) END-STOP FOR BUSHING
5) SPRING LATCH
6) THROUGH CYLINDER (ON REQUEST)
7) GATE
fig.
fig.
INSTALLING THE ELECTRIC LOCK
Power the system and run a complete opening and closing cycle checking that:
• The safety devices function properly;
• The gate moves smoothly;
• Good hold of the fastening brackets;
• That the power cable moves freely;
• The gate assembly conforms to EN 12453
and
EN 12445;
FINAL CHECKS
Periodically check the gate structure, in particular:
Check functioning of the hinges;
Check that the leafs are correctly balanced. Do the test by unlocking the operator and checking that the leafs do not
move on their own;
Check good functioning of the safety devices;
Unlock the operator and check that there are no points of friction along the entire travel;
Periodically check proper adjustment of the operator thrust force and the efficiency of the unlocking device for
manual operation (see the relative paragraph).
The safety devices installed on the system must be checked every six months.
Ÿ
Ÿ
For any unresolved malfunction, cut the power to the
system
and
call
in
a
qualified
technician
(installer).
In
the
period
when
the
gate
is
out
of
service,
activate
the
manual
unlocking
device
to
allow
manual
opening
and
closing.
MAINTENANCE
MALFUNCTIONING
CE Declaration of conformity
The manufacturer:
GI.BI.DI.
Via Abetone Brennero, 177/B,
46025 Poggio Rusco (MN) - ITALY
declares that the products:
ELECTROMECHANICAL GEARMOTOR SNAPPER 250
are in conformity with the following CEE Directives:
•
EMC Directive 2004/108/CE and subsequent amendments;
and that the following harmonised standards have been applied:
•
•
Date 26/03/18
S.r.l.
Directive
and subsequent amendments;
LVD
2006/95/CE
•
EN60335-1,
EN61000-6-1, EN61000-6-3
Moreover declares that the product must not be used until the machine in which it
has been incorporated has not been declared in accordance with 2006/42/CE
Directive.
The legal Representative
Michele Prandi
