GiBiDi AS05710/115V, Instructions For Installations

Page: 14 / 28

SC230
DIP 8
Reduces the pause time to 2s after the intervention of the photocells.
Disables the fast closing function
ON
OFF
FAST RECLOSING
DIP 10
Terminal 12 (SAFETY-STOP) works as terminal 11 (SAFETY 8K2).
See Chap.5 .
ON
OFF
TERMINAL 12
FUNCTION
DIP 9
Enables the operation of the motor rpm sensor. After a reduction of the
number of motor revolutions (e.g. because of an an obstacle), the sensor intervenes
locking the motion and inverting the direction for 1 s in order to free the obstacle. At the
next Start pulse, the motion restarts in the obstacle freeing direction.
ON
MOTOR RPM
SENSOR
Disables the motor rpm sensor
OFF
Terminal 12 works as STOP 8K2.
The activation of STOP 8K2 device causes an immediate STOP of the automatic
device.
Description DIP Status Function
Disables the deceleration function. Only 2 magnets are required.
DIP 7
Enables the deceleration during both opening and closing, when the
respective limit switch is intercepted. The deceleration speed is adjusted by trimmer
TR3 SLOW. This function provides for use of 4 magnets.
See fig. 7 e 27.
ON
DECELERATION
OFF
9 - DIP SWITCH SW1
DIP 6
Enables automatic closing after the pause time adjustable by the trimmer
TR1 PAUSE from 2 to 220 s.
Disables automatic closing. ON
OFF
AUTOMATIC
RECLOSING
DIP 5
When the photocell is intercepted, during both opening and closing, the
gate motion is locked until the photocell is freed.
Subsequently there is always an opening phase.
ON
PHOTOCELL IN
OPENING
OFF
Photocell enabled only during closing,when it is intercepted the gate opens.
DIP 4
Enables the TEST of the devices connected to the terminals (10)-(11)-(12): if the
devices are working perfectly, the cycle can start, otherwise some prolonged
flashings will indicate the anomaly.
Ÿ
Terminal (10 - “PHOTO”): power the photocells’ transmitters by the terminal (16) and
the receivers by the terminal (15 - ” 24Vac”). At the beginning of the manoeuvre, the
current will be cut to the transmitters for 1 second and then restored to check its right
operation.
Ÿ Terminal (11 - “SAFETY”) and (12 if DIP10=ON ): the resistive value 8K2 Ω is
checked
Enables ENERGY SAVING: There will be some tension on terminal (16) only during
the manoeuvre. At rest the leds will be off.
ON
Disables the safety devices test.
Disables ENERGY SAVING
OFF
ENERGY SAVING
SAFETY DEVICES TEST
UK
14