3
U.S.
Metric
Volume (MP4130-3100)
......................................... 15.4 GPM ......................................... 58.2 L/min
Volume (MP4135-3100)
......................................... 17.9 GPM ......................................... 67.7 L/min
Discharge Pressure ................................................ 1600 PSI ................................................ 110 Bar
Inlet Pressure ........................................................ 90 PSI ................................................... 6.2 Bar
Speed ..................................................................................................................... Up to 1100 RPM
Plunger Diameter................................................... 1.2” ...........................................................
30mm
Plunger Stroke (MP4130-3100)
............................. 1.0” ...........................................................26mm
Plunger Stroke (MP4135-3100)
............................. 1.8” ...........................................................
30mm
Crankcase Oil Capacity .........................................
33.8 fl.oz.
................................................1 Liter
Temperature of Pumped Fluids ............................. Up to 158
o
F ............................................. 70
o
C
Inlet Ports ......................................................................................................................... (2) 1” NPT
Discharge Ports .............................................................................................................
(2) 3/4” NPT
Pulley Mounting ................................................................................................................Either side
Shaft Rotation .................................................................................Top of Pulley Towards Fluid End
Weight ................................................................... 66 lbs. .....................................................
30 Kg
Crankshaft Diameter.............................................. 1.1” ...........................................................28mm
MP4130-3100 & MP4135-3100
Pump Specifications
Consult the factory for special requirements that must be met if the pump is
to operate beyond one or more of the limits specified above.
PULLEY INFORMATION
Pulley selection and pump speed are based on
a 1725 PRM motor and “B” section belts. When
selecting desired GPM, allow for a ±5% tolerance
on pumps output due to variations in pulleys, belts
and motors among manufacturers.
1. Select GPM required, then select appropriate
motor pulley from the same line.
2. The desired pressure is acheived by selecting
the correct nozzle size that corresponds with the
pump GPM.
HORSEPOWER RATINGS:
The rating shown are the power requirements for
the pump. Gas engine power outputs must be
approximately twice the pump power require-
ments shown above.
We recommend a 1.15 service factor be specified
when selecting an electric motor as the power
source. To compute specific pump horsepower
requirements, use the following formula:
HP = (GPM X PSI) / 1450
RPM
GPM
500 PSI
1000 PSI
1300 PSI
1600 PSI
700
9.8
3.4
6.8
8.8
10.8
800
11.2
3.9
7.7
10.0
12.4
900
12.6
4.3
8.7
11.3
13.9
1000
14.0
4.8
9.7
12.6
15.4
1100
15.4
5.3
10.6
13.8
17.0
MP4130-3100 Horsepower Requirements
RPM
GPM
500 PSI
1000 PSI
1300 PSI
1600 PSI
700
11.4
3.9
7.9
10.2
12.6
800
13.0
4.5
9.0
11.7
14.4
900
14.6
5.1
10.1
13.1
16.2
1000
16.3
5.6
11.2
14.6
18.0
1100
17.9
6.2
12.3
16.0
19.8
MP4135-3100 Horsepower Requirements
