2
safety rules regarding outdoor power equipment (cont.)
• Belts and belt guard components are subject to
wear, damage, and deterioration, which could
expose moving parts or allow objects to be thrown.
Frequently check components and replace with
manufacturer’s recommended parts, when
necessary.
• Check operation of brake, tail and license lights
frequently. replace as required.
• Use only factory authorized replacement parts
when making repairs.
• Always comply with factory specifications on all
settings and adjustments.
• Only authorized service locations should be
utilized for major service and repair requirements.
• Never attempt to make major repairs on this unit
unless you have been properly trained. Improper
service procedures can result in hazardous
operation, equipment damage and voiding of
manufacturer’s warranty.
3
unit assembly & set-up
Note: Please refer to Parts List for correct part identification and placement. Parts list reference numbers
are called out by sheet number followed by reference number(s) on that sheet: (1:1) indicates Sheet 1,
reference number 1; (2:32,34-38) indicates Sheet 2, reference numbers 32 through 38 excluding 33; etc.
Important Safety Note: To prevent unit rollover during assembly and set up, lock
rear support leg in lowermost position possible. Failure to do this may result in
injury or death and/or damage to unit or property.
Manual No. 3100022
DISCHARGE ASSEMBLY
Safety Note: Assistance is required when installing discharge stack. If access to lifting
equipment is possible, it is highly recommended.
•
Place stack & elbow assembly (3:1) atop
power unit, with discharge directed toward
towing hitch. Insert twelve 1/2-13 x 1-3/4”
hex bolts (3:2), each fitted with one flat
washer (3:3), through bolt flange holes,
securing with flat washers, lock washers and
nuts (3:3-5). Tighten securely.
Not
for
Reproduction