Copyright All Rights Reserved.
P-MU-DG-900 Ver. D Publish: 2010.08.23 Page: - 5 -/ 6
7. Adding a Proximity Card and PIN to Relay 1
a.
1. Enter programming mode to select slot position
000~999
(Green LED rapid flash to indicate the
slot position is available)
2. Read new card (1 beep), then press 5-digit PIN
99999
(1 beep, Green LED stay on)
3.
Press
#
(1 beep) back to programming mode
4.
Press
#
again (1 beep) back to standby mode (Yellow LED slow flash)
NOTE: Master codes must NOT be the same as PIN codes.
b.
1. Enter programming mode to select slot position
000~999
(Green LED stay on to indicate the
slot position is unavailable
2. Press
＊＊
(1 beep) to delete the data from the slot position (Green LED rapid flash)
3. Repeat the steps of 7-a to add new cards.
8. Adding a Proximity Card and PIN to Relay 2
a.
1. Enter programming mode
2. Press
＊
4
to select slot position
00~09
(Red LED rapid flash to indicate the slot position is
available)
3. Read new card (1 beep, Red LED stay on)
4. Press
#
(1 beep) back to programming mode
5. Press
#
again (1 beep) back to standby mode (Yellow LED slow flash)
b.
1. Enter programming mode
2. Press
＊
4
to select slot position
00~09
(Red LED stay on to indicate the slot position is
unavailable)
3. Enter
＊＊
(1 beep) to delete the data from the slot position (Red LED rapid flash)
4. Repeat the steps of 8-a to add new cards.
9. Change Master Code
1. Enter programming mode
2. Press
＊
3
, then enter 5-digit master code twice e.g.
45678 45678
(1 beep, Yellow LED stay on)
3. Press
#
(1 beep) back to programming mode
4. Press
#
again (1 beep) back to standby mode (Yellow LED slow flash)
10. Add a New Master Card to Relay 1
a.
1. Enter programming mode
2. Press
＊
7
(rapid Green LED flash to indicate the controller without master card stored)
3. Read new card to set as master card (1 beep, Green LED stay on)
4. Press
#
(1 beep) back to programming mode
5. Press
#
(1 beep) back to standby mode (Yellow LED slow flash)
b.
1. Enter programming mode
2. Press
＊
7
(Green LED stay on to indicate the master card had been stored)
3. Press
＊＊
(1 beep) to delete the master card (Green LED rapid flash)
4. Repeat the steps of 10-a to add new master cards.
11. Add New Cards by Master Card
1. Read master card once (1 beep, Yellow LED rapid flash)
2. Enter slot position
001~999
(rapid Green LED flash to indicate the slot position is available)
3. Read new card (1 beep), then enter 5-digit PIN
99999
(1 beep, Green LED stay on)
4. Read master card again, reader back to standby mode (Yellow LED slow flash)
12. Reset the Master Code to Default Value
1. Turn off the power
2. Press
#
continuously, and energized (1 beep), the master code is reset to default value.