Copyright All Rights Reserved.
P-MU-DG-900 Ver. D Publish: 2010.08.23 Page: - 4 -/ 6
V. Operation Instruction
1. Master Code
The master code comprises of a five-digit number and is used to access programming functions of the
digital keypad and cannot be used for access i.e. It cannot be the same as other PINs. The default
master code is set to
12345
. Under normal operation the keypad is used for entering PIN to gain
access. In the programming mode the keypad can be used to add/delete PINs, set relay strike time
and other operation functions.
2. Enter Programming Mode
Press the master code twice (
12345 12345
) to enter programming mode (1 beep, Yellow LED flash).
3. Setting the Access Mode
The dual authentication feature allows the keypad to be programmed to grant access optionally with
either Proximity Card only, or PIN or Proximity Card and PIN.
1. Enter programming mode
2. Press
＊
0
3. Press
00
(1 beep, Yellow LED stay on) for Proximity Card Only
Press
01
(1 beep, Yellow LED stay on) for Proximity Card or PIN
Press
02
(1 beep, Yellow LED stay on) for Proximity Card + PIN
4. Press
#
(1 beep) back to programming mode
5. Press
#
again (1 beep) back to standby mode (Yellow LED slow flash)
4. Setting the Relay Strike Time
The relay strike time determines the amount of time that the door remains unlocked after a valid
proximity card or PIN is entered.
NOTE: For both Relay 1 & Relay 2, enter 00 will set the relay
strike time to 0 second (relay set to toggle mode).
1. Enter programming mode
2. Press
＊
1
for
Relay 1
(rapid Green LED flash)
→
Enter
00~99
(1 beep, Green LED stay on)
Press
＊
5
for
Relay 2
(rapid Red LED flash)
→
Enter
00~99
(1 beep, Red LED stay on)
3. Press
#
(1 beep) back to programming mode
4. Press
#
again (1 beep) back to standby mode (Yellow LED slow flash)
5. Clear Memory of All Proximity Cards and PINs
1. Enter programming mode
2. Press
＊
8
(all 3 LEDs rapid flash)
3. Press
88
(all 3 LEDs stay on, 1 long beep indicating data successfully deleted)
4. Press
#
(1 beep) back to programming mode
5. Press
#
again (1 beep) back to standby mode (slow Yellow LED flash)
6. Reset Controller Parameter to Default Value
1. Enter programming
2. Press
＊
8
(all 3 LEDs rapid flash)
3. Press
99
(all 3 LEDs stay on, 1 long beep indicating data successfully deleted)
4. Press
#
(1 beep) back to programming mode
5. Press
#
again (1 beep) back to standby mode (Yellow LED slow flash)