E-HYBRIDE CROSS
E-HYBRIDE TREKKING
E-HYBRIDE WAVE
Original operating instructions 12/2012
56
GHOST EPAC
5.
Lower the fork carefully until the axle is flush with the stop of the fork ends on
the left and right.
•
When clamping with the quick-release axle
Close the quick-release axle in accordance with section 8.4.1, Opening,
closing the quick-release axles .
6.
If your EPAC has been retrofitted with a hub dynamo:
Reconnect the plug connector between hub dynamo and wiring.
7.
Operate the front wheel brake several times with the EPAC stationary after you
have reinstalled the front wheel.
8.
Lift up the EPAC by the handlebars and turn the front wheel by hand. If a brake
block is in contact with the wheel rim, this can indicate incorrect mounting of the
hub in the fork dropouts. In this case you should open the quick-release lever
and shake the front wheel lightly to and fro (at right angles to the direction of
travel). Repeat the installation from step 5. If this does not improve the situation,
contact your specialist bicycle dealer immediately.
9.
If your EPAC has been retrofitted with a hub dynamo:
Check that the lights are working correctly.
See section 6.9, Checking the .
13.1.3 Dismantling the rear wheel
1.
Shift to the smallest pinion of the sprocket assembly on the rear wheel (see
section 8.2.2, Switching to a smaller sprocket:.
2.
Operate the rear brake until the rear wheel comes to a complete stop.
3.
Open the lever of your quick-release axle in accordance with section 8.4.1,
Opening, closing the quick-release axles .
4.
Raise the bike at the rear end and push the gear shift mechanism to the rear. In
this position, push the rear wheel with alight pressure towards the opening in
the frame.
