46
P U S H - T O - O P E N
© G h o s t C o n t r o l s
®
2 0 2 0
CONNECTING OPERATOR ARM TO CONTROL BOX
STEP 9.
Insert the operator cables into the control box.
A. Route the operator cable through the strain relief and into the control box.
B. Connect the operator wires to the control board. Find the 1st operator screw terminal on control board and
insert the red, black, green and white wires (left to right) into the matching color coded terminals and tighten
each of the screws so that the wires do not come loose and fall out. Then continue with connecting the second
operator wires.
C. Make sure wires are not inserted too far into the terminal slots and that the wire insulation is not interfering
with contact to the system control board.
D. Tighten strain relief nuts on the control box to close the seals around the wires.
B
