GHM Delta OHM HD50CR-AS, Operating Manual

Page: 14 / 32

HD50CR-AS
- 14 -
V1.1
F413 : upper alarm threshold
F414 : upper alarm threshold enabling {On/OFF, default=On}
F415 : alarm hysteresis in % of the difference between the two alarm thresholds
{0…100 %, default=2%}
F416 : delay time in signaling the alarm {max. 960 min, default=0}
F417 : buzzer enabling {On/OFF, default=OFF}
F418 : buzzer “Latch” function enabling {On/OFF, default=OFF}
F419 : buzzer silencing time, in minutes {0…1080, default=0}
.
.
.
F460 : alarm of the quantity of index 6
F461 : lower alarm threshold
F462 : lower alarm threshold enabling {On/OFF, default=On}
F463 : upper alarm threshold
F464 : upper alarm threshold enabling {On/OFF, default=On}
F465 : alarm hysteresis in % of the difference between the two alarm thresholds
{0…100 %, default=2%}
F466 : delay time in signaling the alarm {max. 960 min, default=0}
F467 : buzzer enabling {On/OFF, default=OFF}
F468 : buzzer “Latch” function enabling {On/OFF, default=OFF}
F469 : buzzer silencing time, in minutes {0…1080, default=0}
F500 submenu (UNIT MEAS MENU)
Units of measurement.
F501 : temperature unit of measurement {°C/°F, default=°C}
F502 : differential pressure unit of measurement {hPa / kPa / atm / mmHg / mmH
2
O /
inHg / inH
2
O / (kgf /cm
2
) / PSI / mbar / bar / Pa, default=Pa}
F600 submenu (LOG MENU)
Logging settings.
F601 : logging enabling/disabling {On/OFF, default=On}
F602 : choice between cyclical management (the new data overwrite the old ones when
the memory is full) or non-cyclical management (logging stops when the
memory is full) of the instrument internal memory {YES=cyclical management
/ NO=non-cyclical management, default=YES}
F603 : logging interval (if it is higher than the measuring interval, the average of the
measurements acquired during the interval will be stored) {default=30 s}
F604 : measurements acquisition interval {default=1 s}. If a value higher than the
logging interval is set, the measurements will be detected with interval
equal to the logging interval.
F605 : deletion of all stored measurements from the instrument memory {YES/nO}