www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
ENGLISH
- 18
12.1.i - Wiper adjustment (Fig. 23)
- It is possible to adjust the height of the
wiper and adjust the incidence of the
blades on the floor.
Height adjustment
Height adjustment
- Lower the wiper, using the lever.
- Loosen the screw (55) and lift or lower
the wheel (55a) until the wiper is in the
desired position, then tighten the screw
(55).
Incidence adjustment
- Lower the wiper, using the lever.
- Start the aspirator and proceed for a few
metres, then turn off the aspirator and
stop the machine.
- Check the incidence of the rubber (60)
blades.
Fig. A
= too low
Fig. B
= too high
Fig. C
= correct position
- Use the grey knob (64) for adjustment,
turning it anticlockwise to increase the
incidence and in the other direction to de-
crease it.
12.1.l - Battery charger and digital
instrument configuration
(Fig. 24)
WARNING:
The machine leaves production with a
standard configuration for operation with
“Sonnenschein” gel batteries.
WARNING:
Disconnect the battery plug from the
socket.
- Remove the cover (61 Fig. 24) by un-
screwing the screws (62 Fig. 24).
Standard configuration with Sonnen-
schein gel batteries
- Remove the cap (66) located under the
batter charger (16).
- Position the switches (DP1 and DP2) as
shown in figure “A”.
It is possible to modify the configuration as
follows:
Configuration for gel batteries which are
not Sonnenschein version
- Remove the cap (66) located under the
battery charger (16).
- Position the switches (DP1 and DP2) as
shown in figure “B”.
Configuration for acid batteries
- Remove the cap (66) located under the
battery charger (16).
- Position the switches (DP1 and DP2) as
shown in figure “C”.
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
By pressing the button (45)
“
” ithe display does not
turn on.
Low battery.
Main fuse blown.
The battery’s plug is still lo-
cated in the charger’s outlet.
Check that the battery is
charged.
Replace the main 5A or 80A fuse.
Place the plug correctly.
The brush does not rotate.
Function card damaged.
Display card damaged.
The touch sensor on the
handle is defective.
Brush motor damaged.
Brush button not pressed.
Replace.
Replace.
Replace.
Replace.
Press the relative button.
Aspirator does not work.
Function card damaged.
Display card damaged.
Intake motor damaged.
Aspirator button not pressed.
Recovery tank full.
Replace.
Replace.
Replace.
Press the button.
Empty, wash and clean the
tank and the probes.
The machine does not dry
well, leaving traces of water
on the floor.
Aspirator off.
Aspiration tube blocked.
Dirty wiper.
Recovery tank full.
Dirty water filter clogged.
Squeegee rubber blades
worn.
Start up the aspirator.
Check and if necessary
clean the aspiration tube that
connects the squeegee to
the recovery tank.
Clean the wiper.
Empty the recovery tank.
Clean the filter.
Replace or turn over the
squeegee rubber blades.
Manuale FRECCIA RAPID 30 Touch_49026100_2ed_07-2018.indd 18
23/07/18 16:24
