Ghibli & Wirbel FR30 E45 Touch, Use And Maintenance

Page: 14 / 24

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
ENGLISH - 8
turn off the aspirator by pressing the
switch (35 Fig. 6).
- Lift the squeegee (11 Fig. 10) by lifting
the lever (3 Fig. 10).
WARNING:
Always lift the wiper and the end piece
after finishing the cleaning operations be-
cause this avoids the deformation of the
rubber blades and of the brush hairs.
- Press the switch (34 Fig. 6) on “0” to turn
off the machine.
- Disconnect the plug from the socket.
7.1.f - Maximum recovery tank water
level alarm (Fig. 11)
If during use of the machine, the vacuum
cleaner turns off, it means that the level of
liquid in the recovery tank has reached the
maximum level.
Go to the water drainage station and drain
the recovery tank as shown in the relative
paragraph.
NOTE:
For the proper operation of the level sensors
it is required to properly clean the inside of
the tank (14 Fig. 14).
8.1 DRAINING THE
RECOVERY WATER
(Fig. 12)
At the end of the washing cycle or when the
recovery water tank (14) is full, it is neces-
sary to empty the tank by proceeding as fol-
lows:
N.B.:
To dispose of the recovery water, comply
with the standards in force in the country in
which the machine is used.
- Position the machine near to a drain out-
let.
- Disconnect the hose (12) from the sup-
port.
- Remove the cap (43) from the hose (12)
and drain all the water contained in the
tank.
N.B.:
The amount of water that comes out can be
modulated by pressing on the end of the tube
(12).
- Put the cap (43) back on the hose (12)
and reposition it on the relative support.
9.1 MAINTENANCE AND
CLEANING
WARNING:
All maintenance operations must be per-
formed with the machine off and tanks
empty.
OPERATIONS TO
PERFORM DAILY
9.1.a - Emptying and cleaning the
clean water tank (Fig. 13)
WARNING:
At the end of the washing operations, it is
compulsory to drain and clean the clean
water tank (5) to prevent deposits or scal-
ing.
After draining the recovery water tank, drain
the clean water tank as follows:
- Position the machine over a drain outlet.
- Disconnect the tube (15) from the hooks,
close the tap (40), lower the tube to the
ground on the drain outlet, open the tap
(40) and let the water drain completely.
- Wash the inside of the tank, leaving the
drain hose open and adding clean water
through the top opening.
- When cleaning is complete, lift the tube
(15), leaving the tap (40) open; couple
the tube in its recesses.
FRECCIA30 E 45_27lingue_2ed_04-2017.indd 8 11/04/17 09:37