Ghibli & Wirbel 13.4180.00, Use And Maintenance

Page: 44 / 604

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
ENGLISH - 16
- To completely drain the water from the
tank (5) disconnect the tube (57) from the
quick connector (58) then turn the con-
nector downwards, letting the water drain
completely; or remove the filter cover
(59).
12.1.b - Cleaning the recovery water
tank (Fig. 17)
WARNING:
At the end of the washing operations, it
is compulsory to clean the recovery wa-
ter tank to prevent deposits or scaling
and the proliferation of bacteria, odours
or mould.
- Drain the recovery water as shown in the
relative paragraph, positioning the ma-
chine over a drain outlet.
- Remove the cover (6).
- Leaving the hose (12) lowered and the
cap off, pour water into the tank (14)
through a hose, cleaning it until clean wa-
ter comes out of the drain hose.
- Clean the level probes (55) using a damp
cloth, taking care not to deform them.
- Replace all the components in reverse
order.
12.1.c - Cleaning the squeegee (Fig.
4)
In order to clean the squeegee correctly (11),
it is necessary to remove it as follows:
- Disconnect the hose (13) from the squee-
gee (11).
- Loosen the knobs (32) and remove the
squeegee (11).
- Wash the squeegee and in particular the
rubber blades (60) and the inside of the
aspiration connector (33).
NOTE:
If, during washing, it is clear that the rubber
blades (60) are damaged or worn, it is neces-
sary to replace them or turn them over.
- Replace all the components in reverse
order.
OPERATIONS TO
PERFORM WHEN
NECESSARY
12.1.d - Cleaning the clean water fil-
ter (Fig. 18)
NOTE:
Before cleaning the filter, make sure the
clean water tank is empty.
- Unscrew and remove the cover (59).
- Remove the filter (17) and wash it in run-
ning water.
- Refit the filter (17) in its seat, then tighten
the cover (59).
12.1.e - Replacing the brush (Fig. 19)
It is necessary to replace the brush when it is
worn more than 2 cm or it must be replaced
depending on the type of floor to be washed;
to replace it proceed as follows:
- Lift up the brush using the pedal as
shown in the relative paragraph.
- Insert a hand under the brush holder unit
(9); to release the brush, turn it abruptly
in the direction of rotation.
- Replace the brush, coupling it manually
to the brush holder flange (9).
- Lower the brush-holder flange (9) using
the pedal, as shown in the relative para-
graph.
- Press the button (45 Fig. 9) to enable the
controls.
- Press the button (52 Fig. 9) to enable
brush rotation.
- Adjust the sensor (20) located on the
handle to start brush rotation.
Manuale FRECCIA 30_49022100_1ed_04-2017.indd.indd.indd 16 12/04/17 16:40