8
HCP
Operation
You can operate the heater using the 4 buttons ON/OFF/+/-.The setting of the
heating power is indicated by a 10-level LED bar-diagram.
The green LEDs 1-4 indicate low power/low temperatures.
The yellow LEDs 5-7 indicate medium power/medium temperatures.
The red LEDs 8-10 indicate high power/high temperatures.
Heating
Switch on the heater using the ON-button on the HCP. The preheating period (6
minutes-default setting) starts on highest setting. All LEDs are on. When the pre-
heating time has elapsed, the normal treatment setting will start (60 minutes-default
setting). You can stop the pre-heating period using the + and - buttons and set the
temperature to one of the 10 levels. Switch off the heater using the OFF-button on
the HCP.
Default settings
Total heating time
60 minutes
LED 6
Pre-heating period
6 minutes
LED 1+2
Power/total operation
30%
LED 1+2+3
Programming
The values of uninterrupted operation, the pre-heating period and the heating
power are programmable.
Use the following combination to enter the programming mode:
