GGMgastro EITC65, User And Operational Manual

Page: 16 / 24

15
To lock the keyboard proceed as follows:
1. Make sure no procedure is in progress.
2. Do not operate for 30 s: the display will show the message “Loc” for 1 s and the keybord
shall lock automatically. To unlock the keyboard:
3. Touch a key for 1 s: the display will show the message “UnL” for 1 s.
Setting the working setpoint
1. Make sure that the keyboard is not locked and that no procedure is in progress.
2. Touch the key: the LED will flash.
3. Touch the or key within 15 s; see also r1 and r2 parameters.
4. Touch the key or do not operate for 15 s: the LED will switch off after which,
the device will exit the procedure. To exit the procedure before the operation is complete:
5. Touch the (any changes will not be saved).
The working setpoint can also be set via SP parameter.
Setting the configuration parameters
To access the procedure:
1. Make sure no procedure is in progress.
2. Touch the
key for 4 s: the display will show “PA”.
3. Touch the key.
4. Touch the or
key within 15 s to set the value determined with the “PAS”
parameter (the parameter is
set at “-19” by default).
5. Touch the
or do not operate for 15 s: the display will show “SP”. To select a
parameter:
6. Touch the or key. To set a parameter:
7. Touch the key.
8. Touch the or key within 15 s.
9. Touch the key or do not operate for 15 s. To exit the procedure:
10. Touch the key for 4 s or do not operate for 60 s (any changes will be saved).
After setting the parameters, suspend power supply flow to the device.