GfS-Day Alarm
Art.-Nr.: 700 000/710 000/730 000/740 000/741000
10
MA_GfS-Tagalarm_0515_GB
SETTINGS FOR REMOTE REED CONTACT
PLACE BATTERY IN REMOTEREED CONTACT
Programming of additional radio reed contacts
Press the program button (Prog) once briefly (1 sec max.).
You will notice a blinking light signal (f =1 Hz). Handle the transmitters one
after the other that shall work with the receiver.
A well received “address” will be confirmed by a long light signal (approx.
4 sec). Each receiver can program a maximum of 32 transmitters.
You end the programming by pushing the program button 3 short times in
sequence (max. 1 sec each time). The light signal turns off and the receiver
is operational. The programming is retained after a long power failure.
Deleting of selected transmitters
It is possible to delete selected transmitters without having to reset the
receiver totally. Push the program button for a minimum of 3 seconds. The
light signal blinks. Operate the transmitter that shall be deleted. This is
confirmed by a long light signal. Push the program button once shortly.
Reset is completed.
Reset
While resetting all programmed transmitters are deleted and the receiver
can be programmed with 32 new transmitters. For a reset push the pro-
gram button for a long time (minimum of 3 sec). The light signal blinks.
Now press the program button once more (minimum of 3 sec).
The memory is erased. This is confirmed by a long light signal. Push the
program button once briefly. The reset is finished.
Programming button
LED
1. Open the device: Press the small tab
on the side and draw-off the cover
towards the top.
2. Insert the included battery CR 2032 (3 V lithium)
inside the battery clip.
3. Mount the counterpart with the raw magnet parallel to the reed
contact.
The distance should not be more than 10 mm!
max 10 mm
