
GB - 22
cleaning the Disc
a defective or soiled disc inserted into the unit can
cause sound to drop out during playback.
Handle the disc by holding its inner and outer edges.
•
Do NOT touch the surface of the unlabeled side of
the disc.
•
Do NOT stick paper or tape on
the surface.
•
Do NOT expose the disc to
direct sunlight or excessive
heat.
•
Clean the disc before playback. Wipe the disc from
the center outward with a cleaning cloth.
•
NEVER use solvents such as benzine or alcohol to
clean the disc.
•
Do NOT use irregular shaped discs (example:
heart shaped, octagonal, etc.). they may cause
malfunctions.
cleaning the unit
•
Be sure to turn the unit off and disconnect the car
power adapter before maintaining the unit.
•
Wipe the unit with a dry soft cloth. If the surfaces
are extremely dirty, wipe clean with a cloth that has
been dipped in a weak soap-and-water solution
and wrung out thoroughly. then wipe with a dry
cloth.
•
Never use alcohol, benzine, thinner, cleaning fluid
or other chemicals. Do not use compressed air to
remove dust.
important note
•
Before transporting the unit, remove any disc from
the disc compartment.
Maintenance
SyMPtoM
cauSe (anD reMeDy)
• Ensure the AC power adapter or car power adapter is connected.
• Make sure that the unit is turned on.
• Remove any obstacles between the remote and the unit.
• Use the remote near the unit.
• Point the remote at the remote sensor on the unit.
• Replace all the battery in the remote with new ones.
• Make sure that you select ON mode.
• Make sure the unit is not paused. Press the
PLay button.
• Make sure the unit is not in fast-forward or fast-reverse mode. Press the
PLay
button.
• Make sure the AUDIO/VIDEO input/output connections are correct.
• The DTS DVD cannot be decoded to have speaker output.
• The unit has overheated. Shut it off for 30 minutes to allow it to cool down.
• The region number of the disc doesn't match the region number of this unit.
• The DVD is dirty. Gently clean the disc.
• The disc is scratched.
• Please adjust the LCD's brightness, contrast and colour using the VIDEO MODE
button on the remote control for the main unit and the brightness, colour control on
the monitor.
• The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with
alcohol.
• Clean the disc.
• There is no disc inside the unit ("No Disc" appears on the screen).
• Insert the disc correctly with the graphics facing up.
• Clean the disc.
• A non-NTSC disc has been inserted, or the disc region number does not match the
region number of the unit.
• Condensation may have formed inside the unit due to a sudden change in
temperature. Wait about an hour for it to clear and try again.
no power.
the remote does not
function.
Very little or no sound
is coming from a DVD.
no picture.
the picture is not clear.
Loud hum or noise is
heard.
the disc does not play.
trouBLeSHootinG GuiDe
Specifications and external appearance are subject to change without notice.